Connect Tech 104 user manual Programming the Fpga

Page 16

Connect Tech FreeForm/PCI-104 User Manual

Programming the FPGA

1)Right click on device number one (Virtex-5 FPGA), and select program. The following diagram will appear. Note that verification will only work if an msk file has been created.

2) Select OK to begin programming. After programming is complete, the status window will report:

Revision 0.00

Image 16

Contents FreeForm/PCI-104 Copyright Notice Limited Lifetime WarrantyTrademark Acknowledgment Customer Support Overview Contact InformationTelephone/Facsimile Email/InternetTable of Contents List of Tables List of FiguresFeatures IntroductionJumpers /Switches Description Components DescriptionHardware Description and Configuration Jumpers and SwitchesSlot Selection RSW1 Position Fpga Configuration Settings J1 Slot Selection RSW1Connector Pinouts External Power Connector Pinout P8 Signal Direction External Power ConnectionGpio Header Pinout Signal Direction Gpio Header P7Hardware Installation Software InstallationStandalone Operation Fpga Development EnvironmentFpga Configuration Launch ImpactPage Page Programming the Fpga Generating a Prom MCS File Page Revision Configuring the Fpga with the SPI Flash Configuring the Fpga / SPI flash AssociationPage Programming the Flash Elapsed time = Reference Design FunctionalityMemory Map Bar Local Address Space 0 BarImplementation Local Address Space 1 BarSpecifications

Related manuals

Manual 26 pages 23.24 Kb