Juniper Networks E320 manual Max 3dBm

E320 8.1.x Module Guide

Cables and connectors	■	One LC full duplex connector
(single-mode [ZX])	■	Transmit power:
		■	min: –2 dBm
		■	max: 3dBm
	■	Receive input power:
		■	min: –22 dBm
		■	max: –3 dBm
	■ See the following corresponding table (ZX Fiber Optic Cabling) for cabling
		requirements.
	■ See E320 Hardware Guide, Chapter 5, Cabling the Router for more information.
LEDs	Board-level LEDs:
	■ OK (green)—IOA is online and is functioning properly
	■ FAIL (red)—Failure detected

Port LEDs:

■LK (green)—Ethernet link is up

■ACT (green)—Blinks when Ethernet traffic is being received

Alarms, errors, and events	■	See Monitoring Ethernet Interfaces in JUNOSe Physical Layer Configuration Guide,
		Chapter 5, Configuring Ethernet Interfaces.

Table 6: SX Fiber Optic Cabling

Fiber Type	Minimal Modal Bandwidth at	Maximum Operating Range (meters)
	850 nm (MHz*km)
62.5 microns	160	220	(656.17 ft)
	200	275	(902.23 ft)
50 microns	400	500	(1640.42 ft)
	500	550	(1804.46 ft)

Table 7: LX Fiber Optic Cabling

Fiber Type	Nominal Wavelength (nm)	Maximum Operating Range
		(kilometers)
9 microns	1310	10 (6.2 miles)

Table 8: LX40 Fiber Optic Cabling

Fiber Type	Nominal Wavelength (nm) Maximum Operating Range
	(kilometers)

24■ GE-8 IOA