Juniper Networks E320 manual Single-mode LR, Single-mode ER

10GE IOA

Cables and connectors	■	One LC full duplex connector
(single-mode [LR])	■	Transmit power:
		■	min: –8.2 dBm
		■	max: 0.5 dBm
	■	Receive input power:
		■	min: –14.4 dBm
		■	max: 0.5 dBm
	■ See the following corresponding table (LR Fiber Optic Cabling) for cabling
		requirements.
	■ See E320 Hardware Guide, Chapter 5, Cabling the Router for more information.
Cables and connectors	■	One LC full duplex connector
(single-mode [ER])	■	Transmit power:
		■	min: –4.7 dBm
		■	max: 4.0 dBm
	■	Receive input power:
		■	min: –15.8 dBm
		■	max: –1.0 dBm
	■ See the following corresponding table (ER Fiber Optic Cabling) for cabling
		requirements.
	■ See E320 Hardware Guide, Chapter 5, Cabling the Router for more information.
LEDs	Board-level LEDs:
	■ OK (green)—Physical link is connected properly and is functioning properly
	■ FAIL (red)—Failure detected

Port LEDs:

■LK (green)—Ethernet link is up

■ACT (green)—Blinks when there is Ethernet traffic being received

Alarms, errors, and events	■	See Monitoring Ethernet Interfaces in JUNOSe Physical Layer Configuration Guide,
		Chapter 5, Configuring Ethernet Interfaces.

10GE IOA ■ 27