Buffalo Technology WBR2-G54 user manual MTU Maximum Transmit, MRU Maximum Receive

Page 42

	Advanced Settings
PPPoE	Authorization - Authorization
Settings	method for accessing the ISP’s
Screen	PPPoE server. If unknown,
	select Auto authorization.
	MTU (Maximum Transmit
	Unit) Size - Maximum Transmit
	Unit (578-1492) when using
	PPPoE.
	MRU (Maximum Receive
	Unit) Size - Maximum Receive
	Unit (578-1492) when using
	PPPoE.

Keep Alive - Enables the PPPoE client to send a Link Control Protocol (LCP) echo request to the PPPoE server

once per minute. If there is no reply within six minutes, the client disconnects. Set to Disable if frequent disconnection occurs.

Activation - Enable/disable registered connection settings. If disabled, the connection is not per- mitted.

42

Image 42

Contents Wireless Cable/DSL Router-G WBR2-G54 Table of Contents Network Settings Table of Contents Introduction AirStation Broadband Router Base Station WBR2-G54AirStation Wireless Network Features Home Networking SOHO/SMB Networking Introduction System RequirementsAirStation WBR2-G54 Package Contents Product ViewsInstallation / Setup About the AirStation CDInstallation / Setup Antenna Installation Setup Preparation Setup OverviewIntroduction Standard Settings Open the Setup ScreenEnter ISP information DSL ButtonAutomatic IP Assignment by ISP Enter IP Address Manually PPPoE ConnectionCatv Cable Button Line Test Security Simple Security Setup Applications Refer to the on-screen help for Aoss Aoss Additional Aoss Information LAN Settings Wireless SettingsAdvanced Settings Wireless LAN Security Data Encryption Disable to haveAdvanced Settings Characteristics LAN Port Dhcp Server Advanced Settings Manual IP MAC Address Assignment Settings Wireless MAC Filter Wireless PC’s ConnectionRegister for Allowable PC’s MAC Address Wireless Bridge WDS Advanced Settings WAN Settings WAN PortConnection Type Select from MTU Maximum Transmit MRU Maximum ReceiveWAN Network Advanced Settings Network Settings Routing SetupRIP transmission to WAN Add Routing Table Entry Address Translation Add NAT Table IP address of WAN SelectAdvanced Settings Packet Filter Basic Filter Setting Advanced Settings MAC Filter Click Enter MAC ﬁ lter to enter MAC address Click Apply when settings are complete Intrusion Detector Select Do not Setting for Intrusion Detector setIntrusion Detector Use , Use or Use Apply Packet ﬁlterPage UPnP Management System InformationAdmin Name Password Time setup NTP server name Enter the NTP server nameWired WAN Wired LAN Wireless LAN Packet Trafﬁc InformationClient Monitor Ping Test Log Information Display log info SelectLog information Displays Log Information Level Syslog TransferSelect Use or Do not use Log Information SelectSave/Restore Settings Reboot/Reload Defaults Click Restart to reboot AirStation Firmware Update Com/wirelessFirmware ﬁle name Aoss Client Table DisplaysAoss Function Click Enable Manually specify the encrypSpeciﬁcations Temperature & HumidityPower Characteristics Additional InformationRegulatory Information Networking CharacteristicsRadio Characteristics Host Operating SystemOpen Ofﬁce Environment Semi-Open Ofﬁce Environment 2412 LED Activity B TroubleshootingCommon Problems Diag LED ActivityChanging Client TCP/IP Settings in Windows Table B.1.1 Diag LED Activity TableLEDs Work But Client PC Cannot Connect to Network Other Problems Problem CauseRestrictions Proper Setup Click on the ‘LAN port’ link on the left Troubleshooting Troubleshooting Glossary DCE Data Communications EquipmentDsss Direct Sequence Spread Spectrum MHz MegaHertz One million cycles per second PCI Peripheral Component Interconnect a ROM Read Only Memory Permanent memoryGlossary Glossary FCC / CE Information Federal Communication Commission Interference StatementImportant Note Federal Communication Commission Interference StatementEU Countries Not intended for use FCC RF Radiation Exposure StatementEU Countries intended for use Potential restrictive useWarranty Information Contact Information General Inquiries4030 W. Braker Ln. Suite Austin, Texas Tel Fax