To mount the switch onto an equipment rack:
1.Place the switch on a flat, stable surface.
2.Locate a
3.Use the screws (supplied) to se- cure the bracket (with a Phillips screwdriver).
4.Repeat the two previous steps on the other side of the unit.
5.Place the switch in the equipment rack.
6.Secure the switch by securing its mounting brackets onto the equipment rack.
Important! Make sure the unit is supported until all of the mounting screws for each bracket are secured to the equipment rack. Failure to do so could cause the unit to fall, which may result in personal injury or damage to the unit.
2.7.2Equipment Rack Guidelines
•Size: 423 x 245 x 43 mm (17.25 x 10.0 x 1.7 inches)
•Ventilation: Ensure that the rack is installed in a room where the temperature remains below 40° C (104° F). Be sure that there are no obstructions, such as other equipment or cables, blocking airflow to or from the vents.
•Clearance: In addition to providing clearance for ventilation, ensure that there is adequate clearance for servicing the switch from the front.
2.7.3Free-Standing/Desktop Placement
The switch has rubber feet for the bottom of the case that allow for se- cure, freestanding placement of the unit.
Follow the steps below for
1.Attach the rubber pads (supplied) to the bottom of each corner of the unit.
16 | Getting Started Guide |
|