Motorola BLE100 operation manual Port Locations, Housing ports

Page 16

Overview2-5

Port Locations

Two housing ports provide connection for coaxial cables. Four port plugs in the cover enable access to internal test points. All ports are protected by factory-inserted threaded plugs or plastic cap plugs. Discard the plastic cap plugs when you install the cable connectors.

Figure 2-5 illustrates the housing port locations.

Figure 2-5

Housing ports

4

2

6

Test ports

	EMB
AS	S	LE
		D
N			O
I
	M EXIC

Test ports

5

1

3

Messenger clamp bolts

Port 1

Lid

Port 2

BLE100 Installation and Operation Manual

Image 16

Contents

Installation BLE100 Special Symbols That Might Appear on the Equipment Page Contents Bench Testing InstallationSpecifications Operating TipsTables Torque Specifications Abbreviations and AcronymsAppendix B Introduction BLE100 closedBLE100 open BLERelated Documentation Using This ManualDocument Conventions If You Need Help Motorola Online http//businessonline.motorola.comCalling for Repairs Overview BLE100 base with electronics moduleOrdering Matrix BLE100 ordering matrixHousing BLE-HSG/15 housing and dimensionsHousing gaskets GasketsHousing ports Port LocationsPower Supply BLE100 power supplyForward Path BLE100 block diagramReturn Path Ingress Control Switch Options and AccessoriesBLE100 options and accessories Model Description FunctionSRE SFE-100SCS RCB JXP Amplifier Setup Proper Handling ProceduresBench Setup Field PracticeForward Path Alignment Before You BeginStarline Cable Equalizers ExampleStarline Forward Equalizers SFE-100 Slope SFE-100Equalizer slope versus cable Frequency Cable slope in dB Starline Cable SimulatorsStarline Cable Simulators Flatness Control Input and Midstage PadsFrequency versus cable slope Bode Equalization Directional Coupler Test PointsLDR/9/1G component layout top-left, bottom-right Temperature Gain Reserve Gain reserve versus ambient temperatureAmplifier Level Control Manual Gain ControlAmplifier Setup Automatic Drive Unit/QAM Automatic Drive Unit Return Path Alignment ADU/QADU Pads and LevelsAlignment Procedure Powering and Surge Protection Bench Testing Before You BeginMeasuring Forward Gain Test Equipment and ConnectionsTest equipment connections for bench sweeping Example Testing Return Gain and Response Completing the Test ProceduresAerial Installation InstallationCenter-conductor pin length J1 position Description Torque sequencePedestal Installation Using Amplifiers in Lower Gain Systems Using Amplifiers in Lower Frequency SystemsOperating Tips Specifications SpecificationModel BLE100S Forward AmplifierReturn Amplifier AC CurrentADU Automatic Drive Unit Torque Fastener Screw Wrench In-lbs Torque SpecificationsSize Abbreviations and Acronyms Visit our website at 527548-001 04/06