Motorola manual UbiSurf SM56

Page 2

UbiSurf SM56

Notices

Trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Motorola disclaims any proprietary interest in trademarks and trade names other than its own.

Image 2

Contents

AT Command Reference Manual UbiSurf SM56 Introduction Page AT and AT& Commands Speaker Control Speaker VolumeReturn to On-Line Mode Pulse DialResult-Code Format Reset Modem Parameters to Default ConfigurationTone Dial Select Call-Progress Result Codes to ReturnPulse Cycle Initialize modem to default factory configurationDial TX Level CTS ControlAT% Percent and AT\ Backslash Commands Maximum Modulation RateMinimum Modulation Rate Data Compression DC ModeDisconnect Buffer Delay AT% Percent and AT\ Backslash Commands DTE Flow Control Error-Correction EC ModeBreak Handling Method Disconnect on DTE InactivityDial Wait AT* Asterisk CommandsModulation Mode Low-Speed Operation ProtocolMM14 K56flex Auto-modulation MM15 Only MM16 MM17 MM18 +A8T 8bis Signal and Message Control AT+ Plus Commands+A8E Configuration +DS +DRData Compression DC Reporting Data Compression Control+ES +EB+ER Synchronous Access Mode Configuration +ESA+FLO +ETBM+FCLASS +FMR? +FMI?+FMM? +FRHAT+ Plus Commands +GMR +GMI+GMM +IFC+MR +PMHT +PCW+PMH +PQC +PMHR+PMF +VCID+VGT +VEM+VGR +VIP+VSD +VRID+VRX +VTS +VSM+VTD Enter Voice-Transmission Mode +VTXATS S-Register Commands S12 Escape Code Guard Time S18 Test TimerS11 Tone Length S92 Modem-on-Hold Messaging MonitoringAT#UD Last Call Status Report Format Command SyntaxCommand Response Ffffffff Call Setup Result Codes Multimedia modes DTE-DCE modesErrorControl Active from 3.5.2/V.58 GstnModulationSchemeActive from 3.7.2/V.58CompressionActive from 3.2.2/V.58 CallCleared codes from 3.6.4/V.58-1994CallCleared codes from 3.6.4/V.58-1994 Modem response line Description Event Reporting Word Busy

Related manuals

Manual 22 pages 12.61 Kb

Manual 42 pages 37.16 Kb

Manual 13 pages 49.27 Kb