Motorola PrPMC800/800ET Processor PMC Module Overview of Start-Up Procedures, Start-Up Overview

1 Preparation and Installation

Overview of Start-Up Procedures

The following table lists the things you need to do before you can use this board and tells where to find the information you need to perform each step. Be sure to read this entire chapter, including all Cautions and Warnings, before you begin.

Table 1-3. Start-Up Overview

What you need to do ...	Refer to ...	On page
		...
Unpack the hardware.	Unpacking the PrPMC800/800ET	4
	Hardware
Make any settings or	Preparing the PrPMC800/800ET Hardware	4
adjustments on the
	PrPMC800/800ET Configuration	4
PrPMC800/800ET module.
	Considerations
Prepare any other optional	For more information on optional devices
devices or equipment you will	and equipment, refer to the documentation
be using.	provided with that equipment.
Install the PrPMC800/800ET on	Installation of a PrPMC800/800ET on a	7
the baseboard.	VME or CompactPCI board
Connect any other optional	Connector Pin Assignments	29
devices or equipment you will
	For more information on optional devices
be using.
	and equipment, refer to the documentation
	provided with that equipment.
Power up the system.	Status Indicators	10
	You may also wish to obtain the PPCBug	65
	Diagnostics Manual, listed in Appendix C,
	Related Documentation.
Examine the environmental	ENV - Set Environment	50
parameters and make any
	You may also wish to obtain the PPCBug	65
changes needed.
	Firmware Package User’s Manual, listed in
	Appendix C, Related Documentation.
Program the PrPMC800/800ET	Preparing the PrPMC800/800ET Hardware	4
module and PMCs as needed
	You may also wish to obtain the	65
for your applications.
	PrPMC800/800ET Processor PMC Module
	Programmer’s Reference Guide, listed in
	Appendix C, Related Documentation.

PrPMC800/800ET Processor PMC Module Installation and Use (PrPMC800A/IH5) 3