Creative 2030 manual Advanced Settings, Advanced tab Configuring the Wireless LAN USB Adapter

Page 52

Advanced Settings

You are advised to use the manufacturer’s default values. If you have changed the original settings, and would like to return to the default settings, click the Restore Defaults button.

1.Click the Advanced tab (see Figure 4-6).

2.Click and drag the Fragmentation Threshold and RTS/CTS Threshold sliders to the rate you want.

3.The Security box will only be highlighted when WEP is enabled. Click the Authentication Type box, and then click the option that matches your access point.

4.Click the Preamble Type box, and then click the preamble type that you want.

5.Click the Apply Changes button to save the settings.

Figure 4-6: Advanced tab

Configuring the Wireless LAN USB Adapter 4-6

Image 52
Contents Page Creative Network Blaster Wireless LAN USB Adapter Contents Configuring Your Computer’s Network Settings Appendixes Product Return Tech Support Warranty Information Safety Precautions Safety Precautions General SafetyFCC Radiation Exposure Statement Introduction Introduction Package Contents Before You BeginDocument Conventions About Wireless LAN Wireless LAN About Wireless LANInstallation Cost Speed Mobility Scalability Ad-hoc mode FlexibilityInstalling Hardware Installing Hardware About Rear View Wireless LAN USB AdapterUSB cable connectors Installing Hardware Page Page Installing Drivers and Configuration Utility Windows 98SE2Add New Hardware 4Add New Hardware After restarting your computer, 8Network Blaster 10Network Blaster 12Configuration Utility Windows14Found New Hardware 16,click the Next button 18,click the Finish button 20Network Blaster 22Network Blaster 24Configuration Utility Windows MeDialog box similar to 28Network Blaster 29Network Blaster 32Configuration Utility Windows XP 33Found New Hardware34,click the Finish button 35Network Blaster 37Network Blaster 39Network Blaster 40Configuration Utility Uninstalling Drivers Configuration Utility Configuring the Wireless LAN USB Adapter Configuring the Wireless LAN USB Adapter Configuration Utility IconConfiguring Settings State boxConfiguration Settings Click the Operating Mode boxSite Survey Settings Site Survey tab Configuring the Wireless LAN USB AdapterEncryption Settings Encryption tabAdvanced Settings Advanced tab Configuring the Wireless LAN USB AdapterAbout tab Configuring the Wireless LAN USB Adapter Configuring Settings Windows XP Using the Wireless Network ConnectionEncryption settings 11Wireless Network Properties dialog box Network Status Using the Configuration Utility Configuring the Wireless LAN USB Adapter Configuring Your Computer’s Network SettingsConfiguring Your Computer’s Network Settings Network Configuration Windows 98 SEClick the Specify an IP Address option to select it Configuring Your Computer’s Network Settings Network Configuration Windows Network Configuration Windows XP OK button to complete the configuration General Specifications Specifications Specifications A-2 Troubleshooting Troubleshooting Windows 98SE/ Me/2000Problems with Software Click Start -Control PanelMy computer is unable to connect to another wireless client Radio Interference Frequently Asked Questions FAQs Frequently Asked Questions FAQs What is a Wireless Access Point? Frequently Asked Questions FAQs C-3 Glossary Glossary Direct Sequence Spread Spectrum Dsss Extended Service Set Identifier Essid Glossary D-4 Local Area Network LAN Glossary D-6 Glossary D-7 Glossary D-8 Glossary D-9 Service and Warranty Information Americas Service and Warranty InformationProduct Return Tech Support Warranty Information Asia Service and Warranty Information E-5 Helpline Information For South Africa For MalaysiaService and Warranty Information E-7