Multitech MT5600ZDXV manual Command &Wn Store Current Configuration, Command %L Line Signal Level

Models MT5600ZDX & ZDXV

Command: &Wn		Store Current Configuration
Values:		n = 0 or no value
Default:		None
Description:		&W or &W0. Store current modem settings in NVRAM
		as profile.
Command: &Zn=x Store Telephone Number
Values:		n = 0, 1, 2, or 3 memory locations
		x = Dialing string
Default:		None
Description:		Stores telephone dial string x in memory location n.
		Dial the stored number using the command ATDS=n.
Command: %En		Monitor Line Quality and Auto-Retrain or Fall-
		back/Fallforward
Values:		n = 0, 1 or 2
Default:		2
Description:	%E0	Disable line quality monitor and auto-retrain.
	%E1	Enable line quality monitor and auto-retrain.
	%E2	Enable line quality monitor and fallback/fall forward.
Command: %L		Line Signal Level
Values:		none
Default:		none
Description:	%L	Returns a value which indicates the received signal
		level. The value returned is a direct indication (DAA
		dependent) of the receive level at the MDP, not at the
		telephone line connector (e.g., 009 = 9dBm, 043 =
		-043 dBm, etc.).
Command: %Q		Line Signal Quality
Values:		none
Default:		none
Description:	%Q	Reports the line signal quality (DAA dependent).
		Returns the higher order byte of the EQM value.
		Based on the EQM value, retrain or fallback/ fall
		forward may be initiated if enabled by %E1 or %E2.
		For example:
		AT%Q
		015

44