Grandstream Networks 386 Admin Password, Home NPA, Layer 3 QoS, Layer 2 QoS, No Key Entry

HandyTone-386 User ManualGrandstream Networks, Inc.

Firmware Key:					(in Hexadecimal Representation)
Onhook Threshold:		800 ms
FXS Impedance:		600 Ohm (North America)
Caller ID Scheme:		Bellcore (North America)
Onhook Voltage:		36V
Polarity Reversal:			No	Yes (reverse polarity upon call establishment and
	termination)

NTP Server:

Syslog Server:

time.nist.gov (URI or IP address)

Syslog Level:

NONE

Update

All Rights Reserved Grandstream Networks, Inc. 2005

Admin Password

Administrator password. Only administrator can configure the “Advanced Settings” page. Password field is purposely blanked for security reason after clicking update and saved. The maximum password length is 25 characters.

Home NPA	Local area code for North American Dial Plan.
Layer 3 QoS	This field defines the layer 3 QoS parameter which can be the value used for
	IP Precedence or Diff-Serv or MPLS. Default value is 48.
Layer 2 QoS	Layer 2 QoS settings. Default setting is blank. Other VLAN supported
	equipments required if configured these settings.
No Key Entry	Default is 4 seconds. User can short or extend that depends on digits dialed
timeout
STUN Server	IP address or Domain name of the STUN server.
Keep-alive interval	Default is 20 seconds. The interval of sending dummy UDP packet to keep
	NAT “pin hole” open.
Use NAT IP	NAT IP address used in SIP/SDP message. Default is blank.
Firmware Upgrade	Default method is HTTP. Firmware upgrade may take up to 10 minutes
and Provisioning	depending on network environment. Do not interrupt the firmware upgrading
	process.

24