RAD Data comm BR-ASX01, BR-ASI01 manual Appendix a Shipping Defaults, Ethernet Port, WAN Port

Page 33

33

Appendix A - Shipping Defaults

Ethernet Port

IP Defaults

•On

•Address: 198.41.12.1

•Subnet Mask: 255.255.255.0

•Broadcast Address: 198.41.12.255

•IP RIP off

IPX Defaults

•802.3 on, autoseeding

•802.2 on, autoseeding

•Type II off

•802.2 SNAP off

AppleTalk Defaults

•Phase I off

•Phase II on, autoseeding

DECnet Defaults

•Off

WAN Port

IP Defaults

•On

•Unnumbered interface

•RIP off

•Van Jacobson compression off

IPX Defaults

•On

•Unnumbered interface

Image 33

Contents

BR-ASI01 BR-ASX01 Page Introduction Available on X model router only WAN Port Frame Relay Configuration Appendix a Shipping Defaults About the BR Router IntroductionRouterView Software Installation Few Notes Getting StartedEthernet Connection Requirements Telco Line Connection Requirements Page Mounting the Router Hardware InstallationConnecting a Line Device to the BR Router Connecting the Router to the EthernetPowering Up the Router Connecting an Out-of-Band Management ConsolePage RouterView for Windows RouterView Software InstallationRouterView for Macintosh Page Page Setting Up Command Line Management Out-of-Band Command-Line ManagementSetting Up Telnet Operation Page Quickstart Instructions Ethernet Port ConfigurationIPX Protocol IP ProtocolDECnet Protocol AppleTalk ProtocolOperating Software IPX Protocol Link Configuration Physical Comm Settings WAN Port Frame Relay ConfigurationIPX Protocol AppleTalk Protocol Frame Relay Dlci Mappings Appendix a Shipping Defaults Ethernet PortWAN Port Link & Physical Defaults Pin Outs for DIN-8 to RS-232 Data Cable DCE/Male Appendix B Connector and Cable Pin OutsPin Outs for DIN-8 to RS-232 Console Cable DTE/Female BR Router Light Patterns Appendix C Light Patterns and Test Switch SettingsAllow letmein password for 5 minutes after powerup BR Router Switch Settings