RAD Data comm BR-ASX01, BR-ASI01 manual Appendix B Connector and Cable Pin Outs

Page 35

35

Appendix B - Connector and Cable Pin Outs

Pin Outs for DIN-8 to RS-232 Data Cable (DCE/Male)

DIN-8 RS-232			DB-25 Data	RS-232
(DTE)			(DCE/Male)
1	RTS	->	4 & 20	RTS & DTR
2	CTS	<-	5	CTS
3	Tx Data	->	2	Tx Data
4	Ground	<->	7	Ground
5	Rx Data	<-	3	Rx Data
6	Tx Clock	<->	15	Tx Clock
7	DCD	<-	8	DCD
8	Rx Clock	<-	17	Rx Clock
Shield		<->	Shield

Notes:

1.DCD must be supported in order for the router to sense a completed connection.

2.Tx Clock direction is determined by an internal jumper. The line device sourcing clock (i.e. <- ) is the default.

Image 35

Contents

BR-ASI01 BR-ASX01 Page Introduction Available on X model router only WAN Port Frame Relay Configuration Appendix a Shipping Defaults About the BR Router IntroductionRouterView Software Installation Few Notes Getting StartedEthernet Connection Requirements Telco Line Connection Requirements Page Mounting the Router Hardware InstallationConnecting a Line Device to the BR Router Connecting the Router to the EthernetPowering Up the Router Connecting an Out-of-Band Management ConsolePage RouterView for Windows RouterView Software InstallationRouterView for Macintosh Page Page Setting Up Telnet Operation Setting Up Command Line ManagementOut-of-Band Command-Line Management Page Quickstart Instructions Ethernet Port ConfigurationIPX Protocol IP ProtocolDECnet Protocol AppleTalk ProtocolOperating Software IPX Protocol Link Configuration Physical Comm Settings WAN Port Frame Relay ConfigurationIPX Protocol AppleTalk Protocol Frame Relay Dlci Mappings WAN Port Appendix a Shipping DefaultsEthernet Port Link & Physical Defaults Pin Outs for DIN-8 to RS-232 Data Cable DCE/Male Appendix B Connector and Cable Pin OutsPin Outs for DIN-8 to RS-232 Console Cable DTE/Female BR Router Light Patterns Appendix C Light Patterns and Test Switch SettingsAllow letmein password for 5 minutes after powerup BR Router Switch Settings