RAD Data comm BR-ASI01, BR-ASX01 manual Pin Outs for DIN-8 to RS-232 Console Cable DTE/Female

Page 36

36

Pin Outs for DIN-8 to RS-232 Console Cable (DTE/Female)

DIN-8 RS-232			DB-25 Data	RS-232
(DTE)			(DTE/Female)
1	RTS	->	5	CTS
2	CTS	<-	4	RTS
3	Tx Data	->	3	Rx Data
4	Ground	<->	7	Ground
5	Rx Data	<-	2	Tx Data
6	Tx Clock	<->	17	Tx Clock
7	DCD	<-	8	DCD
8	Rx Clock	<-	15	Rx Clock
Shield		<->	Shield

Notes:

1.This cable is a null-modem DTE-to-DTE cable.

2.Because it is a null-modem cable, it can be connected “back-to-back” with a DCE/Male data cable in order to create a router-to-router test connection cable.

Image 36

Contents

BR-ASI01 BR-ASX01 Page Introduction Available on X model router only WAN Port Frame Relay Configuration Appendix a Shipping Defaults Introduction About the BR RouterRouterView Software Installation Getting Started Few NotesEthernet Connection Requirements Telco Line Connection Requirements Page Hardware Installation Mounting the RouterConnecting the Router to the Ethernet Connecting a Line Device to the BR RouterConnecting an Out-of-Band Management Console Powering Up the RouterPage RouterView Software Installation RouterView for WindowsRouterView for Macintosh Page Page Setting Up Command Line Management Out-of-Band Command-Line ManagementSetting Up Telnet Operation Page Ethernet Port Configuration Quickstart InstructionsIP Protocol IPX ProtocolAppleTalk Protocol DECnet ProtocolOperating Software IPX Protocol Link Configuration WAN Port Frame Relay Configuration Physical Comm SettingsIPX Protocol AppleTalk Protocol Frame Relay Dlci Mappings Appendix a Shipping Defaults Ethernet PortWAN Port Link & Physical Defaults Appendix B Connector and Cable Pin Outs Pin Outs for DIN-8 to RS-232 Data Cable DCE/MalePin Outs for DIN-8 to RS-232 Console Cable DTE/Female Appendix C Light Patterns and Test Switch Settings BR Router Light PatternsBR Router Switch Settings Allow letmein password for 5 minutes after powerup