GBC 620OS operation manual Loading Film & Threading Film

GBC 620os Operation Manual

LOADING FILM & THREADING FILM

Locking Pins

Figure 1

“O”-Rings

Film Shaft

Film Shaft Support Bracket

Figure 2

Top Idler

Lower Idler

Main Roller

DO NOT USE COLORED PRINTS AS SHOWN IN

PHOTOS FOR THREADING.

STEP 1:

•Preheat the laminator to desired temperature.

•Turn on the Air Compressor.

STEP 2:

•Pull the Locking Pins out of the Film Shaft Support Bracket. (Figure 1).

•Swing the Film Shaft Support Bracket out and slide the roll of film onto the Film Shaft, over the Core Adaptors. (Figure 2).

•Slide the “O”-Ringover the end of the Core Adaptors to keep the roll of film from shifting from side to side. (Figure 2).

STEP 3:

•Guide the film over the Top Idler Bar. (Figure 3).

•Continue by webbing the film under the Lower Idler Bar. (Figure 3).

•Drape the film over the Main Heat Roller. (Figure 3).

•Lower the Idler assembly to the lower position and lock in place.

STEP 4:

•Insert a “Threading Card” into the nip by pressing and holding “LOADING”. The “Threading Card” should be long enough to reach the Pull Rollers into the nip area. NOTE:

Use unprinted material to perform this function. If Printed paper must be used, make sure the printed area of the sheet DOES NOT make contact with the Heat Roller. Continue to feed the Threading Card until the trailing edge clears the Feed Gate and about 3 inches of the image is left exposed. (Figure 4).

•Remove the Front Safety Shield. NOTE: The

Top Main Heat Roller is HOT. Use extreme caution not to touch the Heat Roller.

•Set Motor Speed to lowest speed or speed 1.

Figure 3

Figure 4

© 2007 General Binding Corporation Page 14