GBC 620OS Pull Rollers, Skew Wheel Pressure Adjustment, Skew Wheel Lock Downs, Paper Guides

GBC 620os Operation Manual

FEATURES/ACCESORIES GUIDE

Figure 12

Figure 13

Figure 14

PULL ROLLERS

(Fig. 12– Item F1)

The Pull Rollers are silicone driven rollers that pull the film and media through the machine and into the Bursting

Rollers.

SKEW WHEEL

(Fig. 12– Item G1)

For proper “snapping” of images, the out put must have a “skew” in the paper or a raised “tent” on one side of the output. By adjusting the Skew Wheel, you can adjust the amount of “Skew” or “Tent” needed for proper “snapping”.

SKEW WHEEL PRESSURE ADJUSTMENT

(Fig. 12– Item G2)

The Skew Wheel Pressure Adjustment can be made by turning the screw down for more pressure and up for less.

SKEW WHEEL LOCK DOWNS

(Fig. 12– Item G3)

The Skew Wheel Lock Downs secure the Skew Wheel to the shaft. These are used to relocate the Skew Wheel as needed.

IN LINE PERFORATOR WHEEL

(Fig. 12– Item H1)

The In Line Perforator Wheel “perfs” the edge of the film allowing the images to be “snapped” or “separated”.

PERFORATOR WHEEL TENSION ADJUSTMENT (Fig. 12– Item H2)

The Perforator Wheel Tension Adjustment can be made by turning the screw.

PERFORATOR WHEEL LOCK DOWN

(Fig. 12– Item H3)

The Perforator Wheel Lock Down secures the Perforator Wheel to the shaft. This is used to relocate the Perforator Wheel as needed.

OUTPUT FEED BELTS

(Fig. 12– Item I1)

The Output Feed Belts assist the finished images into the

Burst Rollers.

PAPER GUIDES

(Fig. 13– Item J1)

The Paper Guides catch and orientate the finished images.

REAR SAFETY LATCHES (Fig. 13– Item K1)

The Rear Safety Latches lock the Rear Safety Shield into place.

REAR SAFETY SHIELD

(Fig. 13– Item L1)

The Rear Safety Shield protects the operator from harm.

REAR TABLE

(Fig. 13– Item M1)

The Rear Table catches the finished product.

© 2007 General Binding Corporation Page 12