GBC 620OS operation manual FEATURES/ACCESORIES Guide, Emergency Stop Buttons

GBC 620os Operation Manual

FEATURES/ACCESORIES GUIDE

Refer to the following pages for detailed information on the Features.

Figure 1

Figure 2

Figure 3

Figure 4

EMERGENCY STOP BUTTONS

(Fig. 1– Item A)

There are two EMERGENCY STOPS on the laminator. One is located at the rear of the machine and the other is located on the front.

To engage, press any EMERGENCY STOP to stop the roller movement. To disengage, turn the EMERGENCY STOP clockwise after the emergency condition has been resolved.

FRONT SAFETY SHIELD INTERLOCK LATCHES

(Fig.1-Item B)

The Front Safety Shield Interlock Latches ensures that the Front Safety Shield is inserted properly and if not engaged, the machine will not operate.

FRONT SAFETY SHIELD (Fig.2-ItemC)

The Front Safety Shield prevents entanglement, entrapment, and inadvertent contact with the Heat Roller.

REWINDER (Fig.2-ItemD)

The Rewinder is used to take up any film that is being slit via the In-Line Slitters.

FEED GATE (Fig.2-ItemE)

The Feed Gate controls the images entering the Nip. It will activate according to the paper size selected on the display, and give an even and accurate overlap.

FEED BELTS (Fig.2-ItemF)

The Feed Belts move the images into the Feed Gate and then into the nip.

TABLE SIDE GUIDES (Fig.2-ItemG)

The Table Side Guides are adjustable to ensure accurate feeding.

BURST ROLLER GAP ADJUSTMENT KNOB (Fig.3-ItemH)

The Burst Roller Gap Knob raises and lowers the Burst Roller. Depending on the media and film being used, the operator can raise or lower the Burst Roller to assist in the Burst or Snapping of the images.

DECURLING ADJUSTMENT KNOB (Fig.3-ItemI)

The Decurling Adjustment Knob is used in conjunction with the film shaft brake to increase or decrease the amount of curl desired by the operator. The Decurling Bar is located between the Main Rolls and the Pull Rolls.

FEED INDICATOR LED (Fig.4-ItemJ)

The Feed Indicator LED will indicate when the next sheet can be placed on the Feed Table. Sheets should not be placed until the LED is illuminated.

FEED GATE STOPS (Fig.4-ItemK)

The Feed Gate Stops can be adjusted up, down, and left to right to accommodate various media paper thicknesses.

© 2007 General Binding Corporation Page 9