Black Box LES421A, LES422A, LES424A, 1-, 2-, and 4-Port Hardened Serial Servers TCP/IP properties

Page 50

Chapter 8: Listing/Descriptions of Hardened Serial Server Settings

Figure 8-1. Network IP properties.

b. Click “Internet Protocol (TCP/IP)” and then click “Properties.” Change the parameters to the following:

•IP Address = 169.254.102.1

•Subnet Mask = 255.255.255.0

•Default Gateway = 169.254.102.100

Figure 8-2. TCP/IP properties.

Page 50

724-746-5500 blackbox.com

Image 50

Contents 4-Port Hardened Serial Servers Trademarks Used in this Manual Trademarks Used in this ManualFCC and IC RFI Statements NOM Statement Table of Contents Table of Contents Serial Interface SpecificationsSpecifications General Network Specifications NetworkConfiguration over TCP TCP/UDP PortsDimensional Diagrams Specifications Overview Introduction FeaturesOverview What‘s Included Hardware Description 1 1-Port Hardened Serial Server LES421A2 2-Port Hardened Serial Server LES422A LES421A components3 4-Port Hardened Serial Server LES424A LES422A componentsConfiguration Software LES424A componentsConnecting the Power Supply Installation and SetupInstallation and Initial Setup Connecting Hardened Serial Servers to Serial DevicesEthernet Passthrough Port 2 RS-4223 RS-485 Configuring via the Network using a Browser Installation and Initial SetupHardened Serial Server Configuration Hardened Serial Server Operational Connections Direct IP and Virtual COM port connectionInstalling and Starting Hardened Serial Server Software Paired mode setupDiscovering Hardened Serial Servers Configuring the Hardened Serial Server IconsConfiguration Pane Hardened Serial Server Information TableLogin Click Login General Configuration page appears LoggingChanging the Password Navigating the Configuration PagesSetting Up the Hardened Serial Server Name and Password Changing the Hardened Serial Servers NameSetting Up Static IP Addressing Setting Up IP AddressingSetting Up Dynamic IP Addressing TCP Configuration Setting Up Serial PortsSetting Up Port Network Parameters Configuring the Hardened Serial Server UDP Configuration 11. TCP server settingsConfiguring the Hardened Serial Server Setting Up Virtual COM Vcom Operation Setting Up Paired Mode Operation16. IP addresses Configuring When Network Connections will be Forced Closed Configuring the Serial ServerSetting Up Advanced Network Settings Configuring when Data Packets are Sent Configuring the Hardened Serial Server Saving/Restoring the Configuration Settings Adding Virtual COM Ports Removing Virtual COM Ports Downloading Firmware Files Upgrading the Hardened Serial Server FirmwareUpgrading the Hardened Serial Server Firmware Uploading the Firmware to the Hardened Serial Server Operation LED Indicators OperationNetwork at the same IP address Front panel of the LES424A LEDs on the LES424A serial server Using the Reset Switch to Enter Console Mode Reset SwitchUsing the Reset Switch to Initiate a Hardware Reset Using the Reset Switch to Exit Console ModeTesting a Hardened Serial Server Connection DiagnosticsDiagnostics Testing a Virtual COM Port Testing a Hardened Serial Server ConnectionListing/Descriptions of Hardened Serial Server Settings Listing/Descriptions of Hardened Serial Server SettingsListing/Descriptions of Hardened Serial Server Settings TCP/IP properties OFF Listing/Descriptions of Hardened Serial Server Settings Listing/Descriptions of Hardened Serial Server Settings Appendix a Default Server Settings Appendix A. Default Server SettingsTerminal Block Appendix B Connector PinoutsAppendix B. Connector Pinouts DB9 M Connector Standard Ethernet Cable RJ-45 Pinout Blackbox.com Blackbox.com Blackbox.com Black Box Tech Support FREE! Live /7