Sony CPD-E220 service manual #2 Section, Adjustments

Page 11

CPD-E220/E220E/E215E

#2 SECTION 4

 

ADJUSTMENTS

Connect the communication cable of the computer to the connector located on the monitor. Run the service software and then follow the instruction.

I2C Interface Card

I2 C Interface Cable

HD15 Connector Adapter

Computer Video Cable

as a Jig

Landing Fine Adjustment

1.Put the set inside the Helmholtz coil.

2.Set TLH plate to zero position.

3.Input the single green signal.

4.Demagnetize the CRT surface with the hand degausser , and perform auto degaussing.

5.Attach the wobbling coil to the designated part of the CRT neck.

6.Attach the sensor of the landing adjustment unit on the CRT surface.

Purity magnet position

7.Adjust the DY position and purity, and the DY tilt.

8.Fasten DY with screw.

Note: Torque 20 +2-1kgcm

9.Adjust top and bottom pins by pitching DY up and down with two wedges.

Also leave the yaw of DY to physical center position with Another two wedes.

 

a

 

 

c

 

d

“a” and “b” must be equal, and

 

“c” and “d” must be equal.

 

b

 

 

 

 

L/D control specification

±

5

±

7

±

5

 

±

5

±

7

±

5

 

±

5

±

7

±

5

(m)

10.If the corner landing is out of specification, put a disk mag- net for the landing correction.

11.Perform auto degauss in case disk magnets are used.

12.Remove the sensor and wobbling coil.

13.Fix purity magnet on DY with UL black tape.

<How to drive in wedges>

4-1

Image 11
Contents CPD-E220/E215E/E220E Leakage Test Safety CHECK-OUTDiagnosis Power Saving FunctionTiming Specification Table of Contents D Boards Removal DisassemblySection Cabinet RemovalPicture Tube Removal Service PositionBoard Removal Removal of ANODE-CAP Removing ProceduresHarness Location HV Hold Safety Related Adjustment#2 Section AdjustmentsConvergence Specification Section Diagrams ∝ -COM, Deflection Control DEFLECTION, HV, Power Supply Diagram Schematic Diagrams and Printed Board Waveforms Schematic Diagrams of D a, b, c, d Board Schematic diagram Aboard Bboard l CHV Schematic diagram Cboard Dboard l IRFU110 IRFU110A SemiconductorsTRANSFORMER, Flyback Exploded ViewsChassis REF.NO. Part NO. Description Remark REF.NO. Part no Picture TubePacking Materials 101 103 104 105Petp Film Electrical Parts ListCeramic ElectBEAD, Ferrite 0.45∝ H Jump WireRES-CHIP RES, Chip3KV PIN, Connector Terminal PINPLUG, Connector 1P Metalized Film 0.022 ∝ FMetalized Film 0.01∝ F ConnectorCAP, Film Metalized Film 0.022∝ FDiode SR1003 PIN, Connector 3PPLUG, Connector 7P AC SocketTransistor 2SD669AVC Transistor 2SC945-PTransistor 2SA733-QP IC LM358NCarbon Small 100K ResistorCarbon Small 1M Metal OxideCarbon Small 1.5M Carbon Small 560KMetal Oxide Film 150K Carbon Small 1.5KPFC X’FORMER TRANSFORMER, PowerRelay TRANSFORMER, Driver