Installation
6.Read the agreement displayed in the “Software License Agreement” window, and click Continue.
7.Click Agree to accept the agreement and to continue with the software installation.
8.If the “Select a Destination” window is displayed, select a destination volume to install the software, and click
Continue.
9.In the “Standard Install on ...” window, click Install.
10.If a window appears, prompting you to enter your password, enter your Mac password, and then click OK.
11.In the window with the message that you will have to restart your computer, click Continue Installation.
12.In the “Installation completed successfully” window, click
Restart.
13.After your computer restarts, configure the modem to use your account (if it was not pre‐activated), as described in “Activation” on page 23.
Removing the modem
To remove the modem:
1.End your network connection (in Watcher, click
Disconnect).
2.Close Watcher if it is open.
3.If a microSD card is inserted into the modem, ensure youʹve completed any file transfers, and then eject the drive.
4.Pull the modem out of the slot by gripping both sides of the modem and pulling the modem straight out.
Using the USB extension cable and laptop clip
Optionally, you can use the provided USB extension cable and laptop clip. The laptop clip fits on top of your laptop screen and holds your modem. This allows you to use your modem in crowded spaces.
Note: To meet FCC (regulatory) requirements, use only the supplied USB extension cable and laptop clip; other cables and laptop clips should not be used.
|
|
|
|
|
|
|
Document 2131141. Rev | 1.0 | Feb.09 |
|
|
| 19 |
|
|