Philips FW-P78 Tape Playback, Rewind/Fast Forward, When playback is stopped, During playback

Page 20

English

TAPE

Tape Side (only on tape deck 2)

Press íor ëto select the tape side for playback or recording.

The BACK or FRONT appear on the display, depending on the tape side selected.

"T2 <<<" or "T2 >>>" will be displayed.

When recording, the BACK or FRONT display will be flashing.

Auto Reverse Playback (only on

tape deck 2)

Press A. REV to select the different playback modes.

å...... to record or playback on one side of the tape. The tape stops at the

end of one side.

..... to record or playback on both sides of the tape. The tape then

stops.

... to playback continuously on both sides of the tape up to a

maximum of 10 times per side unless you press Ç.

Tape Playback

1Press TAPE ( TAPE 1•2 ) to select TAPE mode.

"TAPE 1" or "TAPE 2" will be displayed, and followed by "T1 or T2" with "<<< or >>>".

Press TAPE ( TAPE 1•2 ) again to select either tape deck 1 or tape deck 2.

2Load the tape into the desired tape deck.

3Press Éto start playback.

If tape 1 is selected for playback;

"T1 " with ">" scrolling right will be displayed.

If tape 2 is selected for playback;

"T2 " with "< or >" scrolling left or right will be displayed depending on the tape side selected.

3a(for playback on tape deck 2 only)

Press íor ëto select tape side (see Tape Side).

Press A. REV to select the different type of playback mode (see Auto Reverse Playback).

4Press Çto end playback.

"T1 or T2" with "<<< or >>>" will be displayed.

Rewind/Fast Forward

When playback is stopped

1You can rewind or fast forward the tape by pressing àor árespectively.

If rewinding, "T1 < or T2 <" with "<" scrolling left will be displayed.

If fast forwarding, "T1 > or

T2 >" with ">" scrolling right will be displayed

The tape will stop automatically at the end of the rewinding or fast forwarding.

2Press Çto stop rewinding or fast forwarding.

During playback

Press and hold àor áuntil the desired passage is located.

"T1 or T2" with "<< or >>" scrolling left or right will be displayed depending on which button is pressed.

During searching, the sound is reduced to a low volume.

When you release àor á, the tape continues playing.

Notes:

During rewinding or fast forwarding of a tape, it is also possible to select another source (e.g. CD, TUNER, or AUX).

Before playing a tape, check and tighten slack tape with a pencil. Slack tape may get jammed or may burst in the mechanism.

C-120 tape is extremely thin and is easily deformed or damaged. It is not recommended for use in this system.

Store the tapes at room temperature and do not put them too close to a magnetic field (for example, a transformer, TV, or speaker).

.

20

Untitled-2

20

6/8/01, 10:13 AM

3139 116 19782

Image 20
Contents Mini Hi-Fi System 3139 116México Minisistema de Audio110-127/220-240 V ~50-60 Hz Philips Mexicana, S.A. de C.V106 Australia/New Zealand/MexicoContents Safety Information FM Wire Antenna Connection PreparationAM Loop Antenna Connection Speakers ConnectionConnecting other Equipment to your system AC Power SupplyInserting batteries into Remote Control Rear Surround Speakers’ ConnectionSetting up the Dolby Pro Logic system Dolby PRO LogicDolby Pro Logic Test ToneDolby Surround Dolby 3 StereoDolby Center Phantom Normal StereoControls 3CDControls on the system and remote control Demonstration mode Operating the SystemSwitching the system on Switching the system to standby modeEasy Set Selecting the SourceFor neutral setting, select Classic and switch off DBB To switch off DBBMute only on remote control Sound ControlDiscs for playback CD Direct PlayLoading the CD Changer Playing a CDDisc Change Selecting a desired trackProgramming Tracks Reviewing the programErasing the program when Tuning to radio stations Storing Preset StationsTuning to Preset Radio Stations TunerChanging the MW tuning grid TapeLoading a tape Not available for version /30When playback is stopped Tape PlaybackRewind/Fast Forward During playbackThere are two Auxiliary modes Normal AUX mode AUX/CDRKaraoke Microphone MixingOnly å or ∂ mode is available during recording RecordingRecording from other sources It is not possible to change tape side during recordingOnly å mode is available during dubbing CD Synchro Start RecordingDigital Recording via Digital Out Press Çto stop dubbingTimer Timer SettingClock Setting ClockSleep Timer Timer will not activate if a recording is in progressTo switch off the Timer To switch off the Sleep TimerSpecifications Maintenance Troubleshooting MaintenanceCD Player Operation Radio ReceptionTape Deck Operation GeneralEnglish