Philips FW-P78 manual Timer Setting, View Clock, Clock Setting

CLOCK

English		NEWS T.A. AM MW FMLW				FRONT HSD		C
	MINI HIFI SYSTEM	PROGRAM SHUFFLE				STEREO	L	R
		REPEAT TIMER REC				BACK
		60Hz	250Hz 500Hz	1KHz	2KHz 4KHz 8KHz			PRO LOGIC
							S	S
	STANDBY
	ON
	CLOCK/	CD1 • 2 • 3	BAND	TAPE 1 • 2		CDR / VIDEO
	TIMER
		CD	TUNER		TAPE	AUX
		PROG		SIDE A•B		▲ PRESET ▲	A.REV
		SEARCH • TUNING	STOP • CLEAR PLAY		PAUSE	PREV SIDE NEXT
	DUB
	(HSD)
								MIC
	REC		SOUND NAVIGATION					LEVEL
		DIGITAL SOUND			DYNAMIC BASS			MIC
		CONTROL			BOOST

5Press CLOCK/TIMER again to store the setting.

™ The clock starts.

•To exit without storing the setting, press Çon the system

Notes:

–During clock setting, if no button is pressed within 90 seconds, the system will exit clock setting mode automatically.

–When a power interruption occurs, the clock setting is erased.

TIMER

Timer Setting

•The system can switch on to CD, TUNER, or TAPE 2 mode automatically at a preset time. It can serve as an alarm to wake you up.

•Before setting the timer, make sure the clock is set correctly.

•The timer will always be switched on once it is set.

•The volume of the timer will increase from the minimum level until the volume level before the set is switched to standby mode.

View Clock

You can view the clock (if it is set) if the system is in Standby mode or when any sound source is selected (CD, TUNER, etc.). The clock will be displayed for about 7 seconds.

•Press CLOCK/TIMER briefly.

™"PM 10:38 or 22:38" (the current time) will be displayed depending on whether you have selected 12- or 24-hour mode.

™"--:--" will be displayed if the clock is not set.

Note:

–When the system goes into low power standby mode, the clock setting will not be displayed.

24

Clock Setting

The clock can be set in either 12- or 24- hour mode, e.g. "AM 12:00" or "00:00". Before setting the clock, you must be in the View Clock mode.

1Press CLOCK/TIMER to select clock mode.

2Press PROG (on the system only) to select 12- and 24- hour mode.

™If 12-hour mode is selected,

"AM 12:00" starts flashing.

™If 24-hour mode is selected, "00:00" starts flashing.

3Set the hour with àor á on the system.

4Set the minute with íor ë on the system.

1Press and hold CLOCK/TIMER for more than 2 seconds to select timer mode.

™“ AM 12:00” or “00:00" or the last timer setting starts flashing depending on whether you have selected 12- or 24-hour mode.

™The TIMER starts flashing.

™The selected source is lit while other available sources are flashing.

2Press CD, TUNER or TAPE to select the

desired source.

•Before selecting CD or TAPE, make sure

a CD or tape is loaded in the CD tray or tape deck 2.

3Press àor á on the system to set the hour for the timer to start.

4Press íor ëon the system to set the minute for the timer to start.

Untitled-2 24 6/8/01, 10:13 AM 3139 116 19782