Dell R805 E1B01, Overcurrent, E2010 No Memory, E2011 Mem Config, Err, E2012 Unusable, Fail, E2015

Table 1-6. LCD Status Messages (continued)

Code	Text	Causes	Corrective Actions
E1B01	USB#	Device plugged in the	Reseat the device cable. If
	Overcurrent	specified USB port caused	the problem persists,
		an overcurrent condition.	replace or remove the
			device.

E2010 No Memory	No memory is installed in
	the system.

Install memory. See "Installing Memory Modules" on page 117.

E2011	Mem Config	Memory detected, but is not	See "Troubleshooting
	Err	configurable. Error detected	System Memory" on
		during memory	page 150.
		configuration.
E2012	Unusable	Memory is configured, but	See "Troubleshooting
	Memory	not usable. Memory	System Memory" on
		subsystem failure.	page 150.
E2013	Shadow BIOS	The system BIOS failed to	See "Troubleshooting
	Fail	copy its flash image into	System Memory" on
		memory.	page 150.
E2014	CMOS Fail	CMOS failure. CMOS RAM	See "Getting Help" on
		not functioning properly.	page 175.
E2015	DMA	DMA controller failure.	See "Getting Help" on
	Controller		page 175.
E2016	Int	Interrupt controller failure.	See "Getting Help" on
	Controller		page 175.
E2017	Timer Fail	Timer refresh failure.	See "Getting Help" on
			page 175.
E2018	Prog Timer	Programmable interval	See "Getting Help" on
		timer error.	page 175.
E2019	Parity Error	Parity error.	See "Getting Help" on
			page 175.
E201A	SIO Err	SIO failure.	See "Getting Help" on
			page 175.
E201B	Kybd	Keyboard controller failure.	See "Getting Help" on
	Controller		page 175.

About Your System

31