Network Computing Devices LSQ-40L quick start manual Programming Using the Scales Keyboards

Page 15

PROGRAMMING USING THE SCALES KEYBOARDS

This Section is for programming and editing without the use of a computer. Before you start programming your scale, you should perform startup operations on pages 4 and 5. This will confirm the scale is operating normally and will make programming easier. You can change the settings later if you need to.

NOTE: At any time you need to enter PROGRAMMING MODE, please follow steps 1 to 3 on page 4 under QUICK TEST OF THE PRINTER.

TO ENTER STORE INFORMATION: (This will be printed on the top of your label)

1). Enter PROGRAMMING MODE.

2). Press PROG. FORMAT.

3). Arrow down until you see HEADLINES. Press ENTER.

4). LINE 1 is displayed. Press ENTER.

5). TEXT is displayed. Press ENTER.

6). MY STORE IS DISPLAYED (or previous text). Press DEL until all text is erased.

7). Type in your stores name and press ENTER.

8). TEXT will appear again. Arrow down until you see SIZE (1-6). Press ENTER.

9). Press DEL. Enter the font size you want. (1=smallest 5=largest). Press ENTER.

NOTE: The larger you make the font; the more space is used on the label. Also fewer characters will appear on label. LINE 1 recommended size is 2.

10). Press Arrow down. POSITION will appear. Press ENTER.

11). By using the arrow buttons, you can select if you want the text to be centered on the label, or start left or right on the label. Press ENTER when selected.

12). Press ESC once. Arrow down to the second line (LINE 2). Press ENTER. Repeat lines 5 to 11 to edit.

Page 15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Quick Start Manual Index Communications with the Scale Cleaning the ScalePage Quick Test of the Printer Setting UP the Scale for First TimePage Configuring Your Network on Your Computer Setting UP the NetworkTo SEE/CHANGE Scales IP Address Configuring Your Network on the ScaleTo ADD a NEW Scale to the Network Starting UP the LSQ-40L SoftwareConfigure General Parameters What YOU can Enter on this Screen Adding Products to the ScaleAssigning Products to the Main Keyboard Moving Products to and from ScaleGeneral Configuration Under the Options BOXBAR Code TAB To Customize a Label General TAB PasswordsPrinted Text on Label Print FormatProgramming Using the Scales Keyboards Edit Scrolling Message To SET Amount of Text Lines to be PrintedConfiguration Enter Setting UP the Label PrintSetting UP the Barcode Removing the BAR CodePlacing Text on the Label Below is a list of what you can put on a label SET UP Text on LabelKEY Assignation Adding PLU’SProgramming Mode Problem Cause Page Limited Warranty Statement How to obtain Warranty Service Important Packing and Shipping Instructions
Top Page Image Contents