Network Computing Devices LSQ-40L quick start manual

Page 4

Network Adapter with category 5 cables

The picture above shows an example of a 5 port hub. One computer and up to 4 scales can be connected for programming.

NOTE: It is not necessary to have a computer to program your scale. Programming can be done by using the keyboard on the scale. However, it is much easier to program using a computer especially if you have more than one scale.

A few other advantages of using a computer are:

1). Information can be saved to your hard drive or other backup device.

2). You can communicate to the scales from a remote location such as a back office. You would not have to go to the machine or move it to program/update.

3). You can generate reports from the scale and print them without interrupting normal operations of the day.

Page 4

Image 4

Contents Quick Start Manual Index Cleaning the Scale Communications with the ScalePage Setting UP the Scale for First Time Quick Test of the PrinterPage Setting UP the Network Configuring Your Network on Your ComputerConfiguring Your Network on the Scale To SEE/CHANGE Scales IP AddressStarting UP the LSQ-40L Software To ADD a NEW Scale to the NetworkConfigure General Parameters Adding Products to the Scale What YOU can Enter on this ScreenMoving Products to and from Scale Assigning Products to the Main KeyboardUnder the Options BOX General ConfigurationBAR Code TAB General TAB Passwords Printed Text on LabelPrint Format To Customize a LabelProgramming Using the Scales Keyboards To SET Amount of Text Lines to be Printed Edit Scrolling MessageConfiguration Setting UP the Label Print Setting UP the BarcodeRemoving the BAR Code EnterPlacing Text on the Label SET UP Text on Label Below is a list of what you can put on a labelAdding PLU’S KEY AssignationProgramming Mode Problem Cause Page Limited Warranty Statement How to obtain Warranty Service Important Packing and Shipping Instructions