Plasmon FS3102 manual

Page 27

An attempt to write flash memory failed

The serial number on this system is incorrect

NVRAM checksum invalid, restoring default settings

NVRAM battery is exhausted and needs replacement

Fibre Channel Port <port> link error

Fibre Channel Port <port> is down

Raidtec FS3102 Hardware Installation Guide

Version 1.0

27

Image 27

Contents FS3102 Hardware Installation Guide Safety and Emissions Appendix D Supported Disk Drives Default IP Address Trademarks Modifications PrefaceIntroduction DisclaimerCompliance FCC Radio Frequency Interference StatementFCC Booklet Information Shielded CablesFS3102 System Overview Raidtec FS3102 Block DiagramContact service personnel for assistance if General Precautions and Electrical ConsiderationsCleaning Instructions Safety and Emissions Unpacking Familiarising yourself with the systemOutlines the standard kit supplied with a Raidtec FS3102 What’s in the boxSystem Views System Front View System LED IndicatorsSystem Back View Controller IndicatorsIndicator Colour Description Installing the FS3102 system Installing Disk DrivesInstalling SFPs Optical transceivers Installing a Host Bus Adaptor HBA SFP ReplacementSFP Removal Single Port/Host DAS Configuration Dual Port, Single Host SAN configurationCabling the Host and the FS3102 Dual Port, Multi Host DAS Configuration Configuring the FS3102 Data Hold Time Battery Backup Unit BBUBattery Pack Replacement Policy BBU IndicatorsReplaceable Field Replaceable Units FRUs10Plasmon Technical Support Failure Events Appendix a AlertsBBU Notifications Alert MessagesPage RAID Creation Appendix B RAID FeaturesLogical Volumes RAID LevelsCaching RAID VerifyStripe Size Stripe Unit SizeBackground DisabledAuto Rebuild PriorityAppendix C System Specifications Electrical CharacteristicsEnvironmental Conditions Air Flow Mechanical SpecificationsWeight DimensionsSupported Drive List Appendix D Supported Disk DrivesSupported Protocols Default IP AddressAppendix E Ethernet Interface References Supported InterfacesFCC