Plasmon FS3102 manual Preface, Introduction, Disclaimer, Trademarks Modifications

Page 5

1 Preface

1.1Introduction

This document has been produced to outline the steps required to install a Raidtec FS3102 Raid system. The document also includes some of the features available and includes the systems specifications.

Refer to the FS3102 Management User Guide for detailed instructions on installing the Raidtec Manager TM software.

1.2Disclaimer

The information in this document is subject to change without notice and should not be construed as a commitment by Plasmon Data Ltd. or its agents. Plasmon Data Ltd. assumes no responsibility for any errors that may appear in this document except in so far as alterations may be made subsequent to receiving written indication of the information concerned.

The product description in this document is intended solely for use in operation, installation and maintenance of the Plasmon Data Ltd. Plasmon Raidtec FS3102 Subsystem. Use of this document for all other purposes, without prior written approval from Plasmon Data Ltd. is prohibited.

Copyright © 2005

Plasmon Data Limited

Whiting Way, Melbourn

Nr. Royston Hertfordshire

United Kingdom SG8 6EN

All rights reserved. No part of this document may be reproduced, photocopied, stored on a retrieval system, or transmitted without express permission of Plasmon Data Ltd.

1.3Trademarks

FS3102 is a trademark of Plasmon Data Ltd. All other names, brands, products and services are trademarks or registered trademarks of their respective companies.

1.4Modifications

Changes or modifications not expressly approved by Plasmon Data Ltd. could void the user’s warranty.

Raidtec FS3102 Hardware Installation Guide

Version 1.0

5

Image 5
Contents FS3102 Hardware Installation Guide Safety and Emissions Appendix D Supported Disk Drives Default IP Address Introduction PrefaceDisclaimer Trademarks ModificationsFCC Booklet Information FCC Radio Frequency Interference StatementShielded Cables ComplianceFS3102 System Overview Raidtec FS3102 Block DiagramContact service personnel for assistance if General Precautions and Electrical ConsiderationsCleaning Instructions Safety and Emissions Unpacking Familiarising yourself with the systemOutlines the standard kit supplied with a Raidtec FS3102 What’s in the boxSystem Views System Front View System LED IndicatorsSystem Back View Controller IndicatorsIndicator Colour Description Installing SFPs Optical transceivers Installing the FS3102 systemInstalling Disk Drives SFP Removal Installing a Host Bus Adaptor HBASFP Replacement Cabling the Host and the FS3102 Single Port/Host DAS ConfigurationDual Port, Single Host SAN configuration Dual Port, Multi Host DAS Configuration Configuring the FS3102 Battery Pack Replacement Policy Battery Backup Unit BBUBBU Indicators Data Hold TimeReplaceable Field Replaceable Units FRUs10Plasmon Technical Support Failure Events Appendix a AlertsBBU Notifications Alert MessagesPage Logical Volumes Appendix B RAID FeaturesRAID Levels RAID CreationStripe Size RAID VerifyStripe Unit Size CachingAuto Rebuild DisabledPriority BackgroundEnvironmental Conditions Appendix C System SpecificationsElectrical Characteristics Weight Mechanical SpecificationsDimensions Air FlowSupported Drive List Appendix D Supported Disk DrivesAppendix E Ethernet Interface References Default IP AddressSupported Interfaces Supported ProtocolsFCC