Alert Messages
The following Notifications and Warnings are sent by the controller.
Notifications
Normal operation of power supply in slot <number> restored
Normal operation of fan in slot <number> restored
The temperature in the system is now within the acceptable range
Creating RAID ‘<name>’, useable capacity: <capacity> GB
RAID ‘<name>’ is now accessible
Initialising RAID ‘<name>’
Initialisation of RAID ‘<name>’ deferred for a higher priority RAID
RAID ‘<name>’ initialisation complete
Deleting RAID ‘<name>’
Expanding RAID ‘<name>’ by adding rows
Expanding RAID ‘<name>’ by adding <number of columns> column(s)
Initialising expansion space on RAID ‘<name>’
RAID ‘<name>’ expand complete
Rebuilding RAID ‘<name>’
Rebuild of RAID ‘<name>’ deferred for a higher priority RAID
RAID ‘<name>’ rebuild complete
Disk in bay <number> is no longer part of RAID ‘<name>’
Verifying RAID ‘<name>’
Verification of RAID ‘<name>’ deferred for a higher priority RAID
RAID ‘<name>’ verification complete
Logical volume '<name>' created
Logical volume '<name>' deleted
Logical volume '<name>' capacity expanded to <capacity>
Logical volume '<name>' ID:LUN changed to <SCSI ID>:<LUN>
Logical volume '<name>' changed to '<new name>'
Starting Firmware <version> (<build time and date>) reboot <reboot count>
Network up at IP address <IP address>, netmask <netmask>
Password has changed
Fibre Channel Port <port> is up at <speed> Gb in <fibre channel mode> mode
Warnings
Disk in bay <number> is missing
Disk in bay <number> has excessive errors
Disk in bay <number> is running out of reallocation blocks
Disk in bay <number> has run out of reallocation blocks
Disk in bay <number> has failed
Power Supply Module in slot <number> is not working properly
Fan in slot <number> is not working properly
The temperature in the system has exceeded <threshold value> threshold
The temperature in the system has dropped below 10C/50F
RAID ‘<name>’ initialisation failed to complete
RAID ‘<name>’ verify failed to complete
RAID ‘<name>’ expand failed to complete
RAID ‘<name>’ rebuild failed to complete
RAID ‘<name>’ is degraded due to disk failures
RAID ‘<name>’ is inaccessible due to disk failures
RAID ‘<name>’ has no suitable spare available
Cannot start scheduled verify on RAID ‘<name>’
Controller hardware error
Firmware download checksum failed, the binary may be corrupted
Firmware ID does not match, the binary is not for this product
Raidtec FS3102 Hardware Installation Guide | Version 1.0 | 26 |