2 SafeCom Go Canon
2.3.2Older Canon devices
Note: When SafeCom is responsible for authentication (SafeCom Go Login is started) then the Additional Functions button only works once logged into the SafeCom solution.
1.Press 
to access Additional Functions.
2.Tap System Settings.
3.In System Settings tap Dept ID Management.
4.Tap Off and tap OK.
5.In System Settings tap System Manager Settings.
6.Make sure System Manager ID is blank and tap OK.
7.Tap Done.
On older Canon devices you may want to select MEAP (Pull Print) as the Initial Function. If so, please perform these steps also. Otherwise proceed with the installation of the SafeCom Go Canon software (2.4.2).
8.Press 
to access Additional Functions.
9.Tap Common Settings.
10.In Common Settings tap Function Display Settings.
11.In Initial Function and Function Order Settings tap Settings.
12.Tap MEAP and tap Set as Initial Function.
13.Tap Next. Tap OK.
14.In Common Setting tap Auto Clear Setting.
15.Tap Initial Function. Tap OK.
16.Tap Done.
17.Tap Done.
Note: Step
Proceed with the installation of the SafeCom Go Canon software (2.4.2).
2.4SafeCom Go Canon software installation
The software MUST be installed via the Canon MFP’s web interface. It is NOT possible to send the software via the SafeCom Administrator.
Please refer to the appropriate section:
∙Canon imageRunner ADVANCE series (2.4.1).
∙Older Canon devices (2.4.2).
12 |