Promise Technology VTM310i, VTM610i, VTM210 Viewing IP address and settings, Exiting the CLU

Page 23

Step 7: Setting the IP Address

4.Follow the same procedure to specify the Subnet Mask, Gateway IP Address and DNS Server IP Address.

If you do not have a DNS server, skip the DNS Server IP address.

5.Press Ctrl-A to save your settings.

Automatic IP settings

To make Management Port settings automatically:

1.Press the arrow keys to highlight DHCP.

2.Press the spacebar to toggle to Enable.

3.Press Ctrl-A to save these settings.

Viewing IP address and settings

To view the current IP address and network settings when using DHCP:

1.Press the arrow keys to highlight DHCP.

2.Press the spacebar to toggle to Disable.

The current Management Port settings are displayed.

3.Press the spacebar to toggle DHCP back to Enable.

4.Press Ctrl-A to save these settings and move to the RAID configuration screen.

Exiting the CLU

1.Highlight Skip the Step and Finish and press Enter.

2.Highlight Return to CLI and press Enter.

This completes the Management Port setup. Go to “Step 8: Creating Disk Arrays with WebPAM PROe” on page 24.

23

Image 23

Contents Vtrak Unpacking the VTrak VTrak Installation Task ListVTrak M610i front view VTrak M610i rear view Mounting the VTrak M610i in a Rack Mounting VTrak in a RackRack mount assembly diagram Rackmounted VTrak M310i M210i is similar Mounting VTrak M310i or M210i in a RackSliding flange installation Mounting rail installation Level Number of Drives Installing Disk DrivesDrive Slot Numbering Installing Disk Drives VTrak drive carrier mounting holes Management Path Configuring an IP Storage Area NetworkMaking Management and Data Connections Data PathVTrak DAS connections Configuring Direct Attached StorageMaking Serial Cable Connections VTrak front panel LED display. The M610i is shown Connecting the PowerConnecting the Power Setting the IP Address Viewing MAC and IP Addresses in the CLU Choosing Dhcp or a Static IP AddressViewing MAC and IP Addresses in the CLI Administrator@cli net -a mod -t iSCSI -p 1 -s dhcp=enable Setting up VTrak with the CLI Administrator@cli net -a mod -t mgmt -s dhcp=enable 192.168.10.1 ISCSI Manual IP settings Setting up VTrak with the CLUSetting system date and time Making Management Port settingsExiting the CLU Viewing IP address and settingsAutomatic IP settings Secure Connection Creating Disk Arrays with WebPAM PROeLogging into WebPAM PROe Regular ConnectionWebPAM PROe log-in screen Creating a Disk Array Selecting a LanguageAutomatic Express Logical Drive Creation AdvancedDisk Array Creation Summary Using WebPAM PROe over the InternetLogging out of WebPAM PROe Netherlands Technical Support ServicesContacting Technical Support United StatesTaiwan GermanyItaly Obtaining a Security Certificate ChinaVTrak M610i, M310i, M210i Quick Start Guide