Promise Technology VTM210, VTM610i Setting up VTrak with the CLU, Setting system date and time

Page 22

VTrak M610i, M310i, M210i Quick Start Guide

Setting up VTrak with the CLU

1.At the administrator@cli> prompt, type menu and press Enter. The CLU main menu appears.

Figure 19.CLU main menu

2.With Quick Setup highlighted, press Enter.

The first Quick Setup screen enables you to make Date and Time settings.

Setting system date and time

1.Press the arrow keys to highlight System Date.

2.Press the backspace key to erase the current date.

3.Type the new date.

4.Follow the same procedure to set the System Time.

5.Press Ctrl-A to save these settings and move to the Management Port configuration screen.

Making Management Port settings

By default, DHCP is disabled on VTrak and the default Management Port IP address is set to 10.0.0.1. The TCP Port is set to 2300.

Use a new Management Port IP address to log into the VTrak over your network.

Manual IP settings

To make Management Port settings manually:

1.Press the arrow keys to highlight IP Address.

2.Press the backspace key to erase the current IP Address.

3.Type the new IP Address.

22

Image 22

Contents Vtrak VTrak Installation Task List Unpacking the VTrakVTrak M610i front view VTrak M610i rear view Mounting VTrak in a Rack Mounting the VTrak M610i in a RackRack mount assembly diagram Mounting VTrak M310i or M210i in a Rack Rackmounted VTrak M310i M210i is similarSliding flange installation Mounting rail installation Drive Slot Numbering Installing Disk DrivesLevel Number of Drives Installing Disk Drives VTrak drive carrier mounting holes Data Path Configuring an IP Storage Area NetworkMaking Management and Data Connections Management PathConfiguring Direct Attached Storage VTrak DAS connectionsMaking Serial Cable Connections Connecting the Power VTrak front panel LED display. The M610i is shownConnecting the Power Setting the IP Address Viewing MAC and IP Addresses in the CLI Choosing Dhcp or a Static IP AddressViewing MAC and IP Addresses in the CLU Administrator@cli net -a mod -t mgmt -s dhcp=enable Setting up VTrak with the CLIAdministrator@cli net -a mod -t iSCSI -p 1 -s dhcp=enable 192.168.10.1 ISCSI Making Management Port settings Setting up VTrak with the CLUSetting system date and time Manual IP settingsAutomatic IP settings Viewing IP address and settingsExiting the CLU Regular Connection Creating Disk Arrays with WebPAM PROeLogging into WebPAM PROe Secure ConnectionWebPAM PROe log-in screen Selecting a Language Creating a Disk ArrayAutomatic Express Disk Array Creation AdvancedLogical Drive Creation Logging out of WebPAM PROe Using WebPAM PROe over the InternetSummary United States Technical Support ServicesContacting Technical Support NetherlandsItaly GermanyTaiwan China Obtaining a Security CertificateVTrak M610i, M310i, M210i Quick Start Guide