Packard Bell MT manual Speakers, Location LCD hinge screws

Page 14

1313131313

13

3. Remove the screws (three in each side) securing the hinges.

Fig. 19 Location LCD hinge screws.

Note: In Fig. 19, some of the screws are partly covered by adhesive tape and/or cables.

4. Lift out the LCD assembly.

Speakers

To remove the speakers, first remove the top cover (see Top Cover on page 10), and then perform the following steps:

1. Remove the screws securing the speakers to the casing.

Fig. 20 Location speaker screws.

2.Clear the speaker cables: detach any adhesive tape securing the speaker cables to the main board.

Packard Bell EasyNote MT Disassembly Manual

Image 14

Contents EasyNote MT Table of Contents About this Guide DisassemblyReassembly For More Information Technician NotesAvoid Electrostatic Discharge Power Supply UnitHazardous Voltage Battery Hard Disk DriveDisconnecting and removing hard disk drive MemoryOptical Disk Drive Removing memory compartment cover77777 Remove the screw securing the optical disk drive Keyboard Location tray bezel lock undersideKeyboard Cover Removing keyboardTop Cover Location keyboard cover screws1111111111 Carefully disconnect the two WiFi antenna cables LCD Assembly Location of top cover screwsSpeakers Location LCD hinge screwsBluetooth Optional Location of speaker cable header on the main boardUSB Board Main BoardLocation of speaker brackets screws Cmos Battery Location of main board screwsWireless LAN Adapter TV Tuner OptionalIntel Turbo Memory Optional CPU and Heat SinkCarefully remove the CPU heat sink Hdmi Board Location of screw securing CPUAudio Board SubwooferTV Antenna Optional TouchpadButton Board LCD BezelInverter Board LCD PanelLocation of LCD cable connector Webcam/MicrophoneEasyNote MT Disassembly Manual