SuperSwap Manual
Introduction
Thank you for purchasing Promise Technology’s SuperSwap. The SuperSwap drive housing installs easily into any 5.25” component bay in your PC. SuperSwap’s drive carrier and housing extend the data storage capabilities of your system by allowing you to easily swap most 3.5” form factor ATA hard drives in and out of your PC, without the hassle of opening and closing your PC’s case. SuperSwap accepts Ultra ATA/100 and Ultra ATA/66 drives. When used with Promise Technology’s ATA RAID 1, 3, or 5 products1, SuperSwap allows users to “hot swap” a failed drive without powering down a system while fully protecting hard drive and internal system components.
Specifications
Interface
∙Fits most 3.5” form factor ATA hard disk drives
∙Standard ATA/IDE interface
∙Supports Ultra ATA/100 and Ultra ATA/66 drives and cables
∙
∙**Built in Monitoring of SuperSwap Fan RPM, Temperature & Voltage levels with installation of FastCheck or SuperCheck Monitoring software.
Housing Assembly
∙Dedicated cooling fan
∙Keyed locking mechanism
∙
Drive Carrier
∙Durable metal construction
∙
∙Unique handle design automatically unplugs drive chassis from housing when pulled up
∙Removable drive access cover
Physical/Environmental
Dimensions
∙Housing Assembly: 8.5” x 5.75” x 1.625” (21.59cm x14.605cm x4.128cm)
∙Drive Carrier: 7.75” x 4.625” x 1.625” (19.685cm x 11.748cm x 4.128cm)
Operating Temperature
∙32°F to 122°F (0°C to 50°C) Relative Humidity
1SuperTrak100, SuperTrak66, FastTrak100, FastTrak66
1