Promise Technology C6101SSWP000000-2 warranty Installing Drive Housing Assembly

Page 7

SuperSwap Manual

Installing Drive Housing Assembly

Installing SuperSwap into your PC is a simple process. There are two basic components involved: installing the housing assembly in your system; and installing a hard drive in the drive carrier. Make sure that you’re properly grounded when installing SuperSwap, either by touching a grounded portion of your PC, or by wearing a ground strap.

1.Power down and unplug your PC, then remove its cover.

2.Slide the housing assembly (see Figure 2-1 next page) into one of the 5.25” drive bays of your system.

3.Align the front of the housing assembly with the front of your system, then install the included screws in the four anchor holes (two on each side) of the assembly (see Figure 2-1).

4.Set the hard drive’s jumper setting to Master/Slave/Cable-Select. Consult your hard drive user manual.

5.Connect your PC’s IDE hard drive cable to the IDE HDD connector on the back of the housing assembly (see Figure 2-2). Make sure that the red edge of the cable is corresponds to Pin 1 of the housing assembly’s connector (opposite the fan, and near the power connector; see Figure 2-2).

NOTE: SuperSwap needs an 80-wire/40-pin IDE cable to work properly.

6.Connect the power cable to the power connector (see Figure 2-2) on the back of the housing assembly.

7.After making sure that all connections are properly seated, replace the PC’s cover.

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Trademarks Table of Contents Introduction SpecificationsWarranty Drive Types Key FeaturesUnpacking SuperSwap Getting StartedInstalling Drive Housing Assembly SuperSwap Housing Assembly Rearview Removing/Installing Drives LED Messages Power/Drive Status LEDSuperSwap Manual Event The drive status LED is red TroubleshootingSuperSwap Manual Limited Warranty Appendix a Returning Product For Repair Your Responsibilities C6101SSWP000000-2
Top Page Image Contents