FieldServer instruction manual FS-8700-60 Gardner Denver Manual Hardware Connections

Page 5

FS-8700-60 Gardner Denver Manual

Page 3 of 11

3.Hardware Connections

The FieldServer is connected to the ES/RS2000 Controller as shown in the connection drawing below:

Configure the ES/RS2000 Controller according to manufacturer’s instructions.

1.03Hardware Connection Tips / Hints

If inter-controller communications are set up for the controller, connect to the RS-232 port only. If inter-controller communications are not used, connect to either the RS- 232 or RS-485 port of the Controller.

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Effective for all systems manufactured after May 1 FS-8700-60 Gardner Denver Auto Sentry ES/RS2000Table of Contents Max Nodes Supported FieldServer Mode Comments FS-8700-60 Gardner Denver Manual Driver Scope of Supply Required 3rd Party ConfigurationFieldServer Technologies Description Required 3rd Party HardwareFS-8700-60 Gardner Denver Manual Hardware Connections Example Section TitleColumn Title Function Legal Values None FS-8700-60 Gardner Denver ManualNodes Timing Parameters Column Title Function Legal Values Data will be stored as follows Node1 OperatingData Motorcurrent Map Descriptor Example 2 Polling only specific data itemsFS-8700-60 Gardner Denver Manual Appendix 1. Advanced Topics JDM
Top Page Image Contents