Maxtor 80-160GB manual 1AT Jumper Options

Page 20

Installation

The configuration of the following three jumpers controls the drive’s five modes of operation:

CS – Cable Select

DS – Drive Select

CLJ– Cylinder Limitation Jumper

The AT PCB has two jumper locations provided to configure the drive in a system. The default configuration for the drive as shipped from the factory is with a jumper across the CS location, and open positions in the DS and CLJ positions.

Table 3-1 defines the operation of the master/slave jumpers and their function relative to pin 28 on the interface. 1 indicates that the specified jumper is installed; 0 indicates that the jumper is not installed.

 

 

 

Table 3-1AT Jumper Options

 

 

 

 

CS

DS

Pin 28

DESCRIPTION

 

 

 

 

 

 

 

 

0

0

X

Drive is configured as a slave.

 

 

 

 

1

0

Gnd

Drive is configured as Master (Device 0) when attached to the end of a 80

 

 

 

conductor Ultra ATA cable.

 

 

 

 

0

1

X

Drive is configured as a Master.

 

 

 

 

1

0

Open

Drive is configured as a Slave (Device 1) when attached to the middle of a 80

 

 

 

conductor Ultra ATA cable.

 

 

 

 

1

1

X

Drive is configured as a Master with an attached slave that does not support

 

 

 

DASP.

 

 

 

 

Note: In Table 3-1, a 0 indicates that the jumper is removed, a 1 indi- cates that the jumper is installed, and an X indicates that the jumper setting does not matter.

Maxtor DiamondMax 17 80-160GB AT Hard Disk Drive

3-5

Image 20
Contents ATA Patents RevisionsUL/CSA/VDE/TUV/WEEE/RoHS Before You Begin Corporate HeadquartersTable Of Contents Service and Support List of Figures List of Tables Audience Manual OrganizationTerminology and Conventions ATAReferences Introduction General Description Product OverviewKEY Features Regulatory Compliance Standards Hardware Requirements Installation Space RequirementsUnpacking Instructions 220 Pack Shipping Container ATA Interface Connector Hardware Options1AT Jumper Options Cable Select CS Jumper ATA Bus Adapter CLJ Jumper Out2.1 40-Pin ATA Bus Connector ATA BUS Interface Connector J1, Section C DC Power J1, Section aATA Bus Interface Connector J1, Section C External Drive Activity LEDMounting Orientation7Mounting Screw Clearance Clearance VentilationAdapter Board Installation For Systems with AN ATA Adapter BoardConnecting the Adapter Board and the Drive Operating System Limitations Techniques in Drive Configuration8.4-Gigabytes Barrier Max LBA Capacity System Startup and OperationModel Interface Model 6G080L0 6G160P0 Drive ConfigurationModel Number and Capacity Value Physical DimensionsModel Power Requirements 80GB & 160GB Mode Power CurrentVoltage Tolerance Voltage TolerancePower Mode Definitions EPA Energy Star ComplianceParameter Non-Operating/StorageParameter Operating Non-Operating Reliability SpecificationsShock and Vibration Safety Regulatory Compliance Canadian Emissions StatementProduct Specifications Signal Cable and Connector IntroductionMechanical Interface Electrical InterfaceCommand Interface General Feature SetSupported Commands Command Command Code Feature Register2fh 3fh Identify Drive Command Word Content Description51-52 Obsolete Total number of user addressable sectors Minimum PIO transfer cycle time with Iordy flow control Minor version number See Address Offset Reserved Area Boot, Incits TR272001 = release interrupt enabled General Purpose Logging feature set supported Word Stream Access Latency DMA Security status ATA Bus Interface and ATA Commands Service and Support Getting HelpService and Support Glossary Glossary Glossary Glossary Positioner See actuator Glossary