Maxtor 80-160GB manual Connecting the Adapter Board and the Drive

Page 30

Installation

3.6.1.1Connecting the Adapter Board and the Drive

Use a 40-pin cable to connect the drive to the board. See figure 3-10.

To connect the drive to the board:

1.Insert the 40-pin cable connector into the mating connector of the adapter board. Make sure that pin 1 of the connector matches with pin 1 on the cable.

2.Insert the other end of the cable into the header on the drive. When inserting this end of the cable, make sure that pin 1 of the cable connects to pin 1 of the drive connector.

3.Secure the drive to the system chassis by using the mounting screws.

Figure 3-10Drive Power Supply and ATA Bus Interface Cables

Maxtor DiamondMax 17 80-160GB AT Hard Disk Drive

3-15

Image 30

Contents ATA Revisions UL/CSA/VDE/TUV/WEEE/RoHSPatents Before You Begin Corporate HeadquartersTable Of Contents Service and Support List of Figures List of Tables Audience Manual OrganizationTerminology and Conventions ATAReferences Introduction General Description Product OverviewKEY Features Regulatory Compliance Standards Hardware Requirements Installation Space RequirementsUnpacking Instructions 220 Pack Shipping Container ATA Interface Connector Hardware Options1AT Jumper Options Cable Select CS Jumper ATA Bus Adapter CLJ Jumper Out2.1 40-Pin ATA Bus Connector ATA BUS Interface Connector J1, Section C DC Power J1, Section aATA Bus Interface Connector J1, Section C External Drive Activity LEDMounting Orientation7Mounting Screw Clearance Clearance VentilationAdapter Board Installation For Systems with AN ATA Adapter BoardConnecting the Adapter Board and the Drive Techniques in Drive Configuration 8.4-Gigabytes BarrierOperating System Limitations System Startup and Operation Model InterfaceMax LBA Capacity Drive Configuration Model Number and CapacityModel 6G080L0 6G160P0 Physical Dimensions ModelValue Voltage Tolerance Power Requirements 80GB & 160GBMode Power Current Voltage TolerancePower Mode Definitions EPA Energy Star ComplianceParameter Non-Operating/StorageReliability Specifications Shock and VibrationParameter Operating Non-Operating Safety Regulatory Compliance Canadian Emissions StatementProduct Specifications Mechanical Interface Signal Cable and ConnectorIntroduction Electrical InterfaceSupported Commands Command InterfaceGeneral Feature Set Command Command Code Feature Register2fh 3fh Identify Drive Command Word Content Description51-52 Obsolete Total number of user addressable sectors Minimum PIO transfer cycle time with Iordy flow control Minor version number See Address Offset Reserved Area Boot, Incits TR272001 = release interrupt enabled General Purpose Logging feature set supported Word Stream Access Latency DMA Security status ATA Bus Interface and ATA Commands Service and Support Getting HelpService and Support Glossary Glossary Glossary Glossary Positioner See actuator Glossary