Maxtor 100462887 Configuring and mounting the drive, Handling and static-discharge precautions

Page 29

3.0Configuring and mounting the drive

This section contains the specifications and instructions for configuring and mounting the drive.

3.1Handling and static-discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis- charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

Caution:

•Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure.

•Handle the drive by its edges or frame only.

•The drive is extremely fragile—handle it with care. Do not press down on the drive top cover.

•Always rest the drive on a padded, antistatic surface until you mount it in the computer.

•Do not touch the connector pins or the printed circuit board.

•Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination.

DiamondMax 20 Serial ATA Product Manual, Rev. A

21

Image 29

Contents Sata Page DiamondMax 20 Serial ATA Product Manual, Rev. a DiamondMax 20 Serial ATA Product Manual, Rev. a Contents DiamondMax 20 Serial ATA Product Manual, Rev. a List of Figures Page Introduction About the Serial ATA interface Specification summary tables Drive specificationsDrive specification STM3160811AS STM3160211AS Drive specifications summary for 160 Gbyte modelsYes Drive specification STM380811AS STM380211AS STM340211AS Drive specifications summary for 80 and 40 Gbyte modelsDiamondMax 20 Serial ATA Product Manual, Rev. a LBA mode Default logical geometryFormatted capacity Cylinders Read/write heads Sectors per track 16,383Recording and interface technology Physical characteristicsTypical seek times msec Read Write Seek timeStart/stop times Power specifications Voltage tolerance Typical current profilesConducted noise Active mode Power-management modesIdle mode Sleep modeEnvironmental specifications Vibration AcousticsOperating vibration Nonoperating vibrationReliability Electromagnetic immunityRadio frequency environments Test Description Performance level Reference standardAgency certification Safety certificationElectromagnetic compatibility Korean RRL European Union Restriction of Hazardous Substances RoHS Environmental protection FCC verification Corrosive environment DiamondMax 20 Serial ATA Product Manual, Rev. a Handling and static-discharge precautions Configuring and mounting the driveSerial ATA cables and connectors Configuring the driveDrive mounting Mounting dimensions-top, side and end viewDiamondMax 20 Serial ATA Product Manual, Rev. a Hot-Plug compatibility Serial ATA Sata interfaceSerial ATA connector pin definitions Serial ATA device plug connector pin definitionsSignal Pin Function DefinitionCommand name Command code in hex Supported ATA commandsSupported ATA commands F4H Word Description Value Identify Device commandXx07H Bit Word Description if bit is set to Bit WordSet Features command values Set Features commandCode in features register A.R.T. command 3 S.M.A.R.T. commandsA.R.T. commands DiamondMax 20 Serial ATA Product Manual, Rev. a Maxtor support services DiamondMax 20 Serial ATA Product Manual, Rev. a Index RRL Sata DiamondMax 20 Serial ATA Product Manual, Rev. a Page Maxtor Corporation