![](/images/new-backgrounds/1110979/11097961x1.webp)
3.4Drive mounting
You can mount the drive in any orientation using four screws in the
•Allow a minimum clearance of 0.030 inches (0.76 mm) around the entire perimeter of the drive for cooling.
•Use only
•The screws should be inserted no more than 0.150 inch (3.81 mm) into the bottom or side mounting holes.
•Do not overtighten the mounting screws (maximum torque: 6
Recommended case temperature measurement location
Dimensions are shown in inches.
Figure 5. Mounting dimensions—top, side and end view
DiamondMax 20 Serial ATA Product Manual, Rev. A | 23 |