FieldServer FS-8704-09 SNMP instruction manual UINT32

Page 39

FS-8704-09 SNMP Driver Manual

Page 39 of 39

Appendix C.1. Exposing Driver Statistics

In addition to the standard FieldServer operating statistics the driver exposes certain key statistics in a Data Array if required. A Server device can then monitor these stats.

Add the following to your configuration file to activate these statistics if the driver is configured as a Client.

// Expose Driver Operating Stats.

 

 

Data_Arrays

 

 

Data_Array_Name,

Data_Format,

Data_Array_Length

snmp-stats,

UINT32,

200

The following statistics are exposed. The table below provides the offset into the Data Array where you will find the statistic.

Offset

Stat

1

There are Server Data Arrays suitable for a walk. The driver sets this offset non-zero if this

 

is true. Read Error message #33 in Appendix C

2

Increments each time a lookup store tries to store at an index > DA length

3

Counts the number of bytes sent by FS in the form of non-COV traps

4

Counts the number of messages sent by FS in the form of non-COV traps

5

Counts the number of bytes sent by FS in the form of COV traps

6

Counts the number of messages sent by FS in the form of COV traps

7

Counts the number of bytes sent by FS in the form of polls

8

Counts the number of messages sent by FS in the form of reads

9

Counts the number of messages sent by FS in the form of writes

10

Counts the number of bytes received by the server. (Excludes Traps)

11

Counts the number of messages received by the server. (Excludes Traps)

12

Counts the number of tap message bytes received by the server.

13

Counts the number of trap messages received by the server.

14

Counts the number of server messages that were received and parsed without error

15

Counts the number of server messages that were received and parsed with error (excludes

 

multiples object requests)

16

Counts the number of server messages that were received and parsed and rejected

 

because they requested multiple objects

17

Counts the number of client side responses that were parsed without error

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com Tel: (408) 262 2299 Fax: (408) 262 9042 Toll Free: (888) 509 1970 email: support@fieldserver.com

Image 39
Contents Applicability & Effectivity Driver Manual FS-8704-09 Snmp VersionTable of Contents Integer Octetstream Timerticks String FS-8704-09 Snmp Driver Manual Snmp DescriptionMax Nodes Supported Required 3rd Party Hardware 3rd Party Client FS-8704-09 Snmp Driver Manual Hardware ConnectionsStation 3rd Party Nodes non-SNMPSnmp Traps Data Arrays/DescriptorsSnmp FS-8704-09 Snmp Driver Manual Client Side Node Descriptors Snmpoid Driver Related Map Descriptor ParametersTiming Parameters RDBC, WRBC, WrbxOID FS-8704-09 Snmp Driver Manual Map Descriptor ExampleDAAI3 Rdbc DAAI3 WrbxServer Side Data Arrays SNMPDA1SNMPDA2 Server Side Map Descriptors Server Side Node DescriptorsAppendix A.1.1. Trap Source IP Address DAAI3 Page FS-8704-09 Snmp Driver Manual Snmpoid 192.168.1.174 Status Normal Status LO Alarm Status HI Alarm Status Normal Status AlarmSNMPDA2 Snmptrap Appendix A.2.2. Polling for Integer bound DataTrap Map Descriptors are then configured as below Page TRAP-TYPE from RFC-1215 FIELDSERVER-MIB Definitions = BeginSnmp Comparison of Style2 to Style3 Comparison of Style1 to Style3 Sample Configuration File Style1 MIB File based on above configuration Style2 MIB File based on above configuration Style3 MIB File based on above configuration Style3 Traps Description Page Trap INTFYI FYI MIBERR SnmptypeseqFS-8704-09 Snmp Driver Manual State=%s FS-8704-09 Snmp Driver Manual UINT32