FieldServer FS-RA-CLX-BAS instruction manual Add and configure the SlotServer as an IO Module

Page 16

FS-RA-CLX_SlotServer_Instruction_Manual_(T17011)

Page 16 of 34

7.2.Step 2: Add and configure the SlotServer as an IO Module

•Right-click on I/O Configuration and select “New Module”.

•Choose the 1756-MODULE

Choose the 1756-MODULE

Be sure to choose the correct Slot number in the rack where your SlotServer reside

Click Next and choose a RPI of 100 ms. This is the rate at which the I/O image data will be transferred

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com Tel: (408) 262-2299 Fax: (408) 262-2296 Toll_Free: 888-509-1970 email: support@fieldServer.com

Image 16

Contents Applicability & Effectivity Table of Contents Appendix B Troubleshooting Tips Introduction About this product Required configuration for the SlotServer RslogixInstall the SlotServer in a ControlLogix Rack Write the SlotServer configurationInstall the FieldServer Utilities Load the SlotServer Configuration into the SlotServerSlotServer Installation SlotServer Ports and DisplaysLED Technical Specifications Inside Cover Door LabelSlotServer Topology Configuring the SlotServer as a Logix I/O Server Data Arrays/DescriptorsServer Side Connection Descriptors Server Side Node Descriptors Driver Specific Map Descriptor Parameters Map Descriptors Example Establish an RSLogix project5 Add and configure the SlotServer as an IO Module Write Ladder Program to get Input Data from Data Arrays FS-RA-CLXSlotServerInstructionManualT17011 Very Important Note Write Ladder Program to Send Output Data to Data Arrays Set up the third party connectionDownload the RSLogix Program and Run Accessing Multiple Output Data Arrays Multiple Input Data ArraysVery Important Note FS-RA-CLXSlotServerInstructionManualT17011 SlotServer Data Transfer over IO Data Image Appendix A.3. How to obtain Node Status from the SlotServer Appendix A.2. The IO image headerAppendix A.4. Dealing with ControlLogix RPI Settings Appendix A.5.2. Setup Appendix A.5.3. RSLogix configurationAppendix A.5.4. RSNetWorx configuration Appendix A.5.5. Testing FS-RA-CLXSlotServerInstructionManualT17011 Appendix A.6. Rules for Naming Logix driver Data Arrays Wrbc CPU1 INT Rdbc CPU1 INTFS-RA-CLXSlotServerInstructionManualT17011 This page Intentionally Left Blank