FieldServer FS-RA-CLX-BAS instruction manual FS-RA-CLXSlotServerInstructionManualT17011

Page 18

FS-RA-CLX_SlotServer_Instruction_Manual_(T17011)

Page 18 of 34

Create a Controller Tag of Type REAL, dimension of 80 for the Destination

•Add an EQU (Compare if equal) ladder element to check when the first Data Array has been received. The block number is at offset 2 of the input image.

•Finally, add another CPS ladder element to copy the LonWorks Data from the InData_Copy Tag to a new Controller Tag, called Lon_In_01. Also create the Tag by right clicking on Destination and choosing New Tag. The New Tag must be of type REAL and a dimension of 76.

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com Tel: (408) 262-2299 Fax: (408) 262-2296 Toll_Free: 888-509-1970 email: support@fieldServer.com

Image 18

Contents Applicability & Effectivity Table of Contents Appendix B Troubleshooting Tips Introduction About this product Required configuration for the SlotServer RslogixInstall the FieldServer Utilities Install the SlotServer in a ControlLogix RackWrite the SlotServer configuration Load the SlotServer Configuration into the SlotServerSlotServer Installation SlotServer Ports and DisplaysLED Technical Specifications Inside Cover Door LabelSlotServer Topology Configuring the SlotServer as a Logix I/O Server Data Arrays/DescriptorsServer Side Connection Descriptors Server Side Node DescriptorsDriver Specific Map Descriptor Parameters Map Descriptors Example Establish an RSLogix project5 Add and configure the SlotServer as an IO Module Write Ladder Program to get Input Data from Data Arrays FS-RA-CLXSlotServerInstructionManualT17011 Very Important Note Set up the third party connection Write Ladder Program to Send Output Data to Data ArraysDownload the RSLogix Program and Run Accessing Multiple Output Data Arrays Multiple Input Data ArraysVery Important Note FS-RA-CLXSlotServerInstructionManualT17011 SlotServer Data Transfer over IO Data Image Appendix A.3. How to obtain Node Status from the SlotServer Appendix A.2. The IO image headerAppendix A.4. Dealing with ControlLogix RPI Settings Appendix A.5.2. Setup Appendix A.5.3. RSLogix configurationAppendix A.5.4. RSNetWorx configuration Appendix A.5.5. Testing FS-RA-CLXSlotServerInstructionManualT17011 Appendix A.6. Rules for Naming Logix driver Data Arrays Wrbc CPU1 INT Rdbc CPU1 INTFS-RA-CLXSlotServerInstructionManualT17011 This page Intentionally Left Blank