FieldServer FS-RA-CLX-BAS instruction manual Appendix B Troubleshooting Tips

Page 3

FS-RA-CLX_SlotServer_Instruction_Manual_(T17011)

Table of Contents


Appendix A.4. Dealing with ControlLogix RPI Settings			26
Appendix A.5. Installing SlotServer on a Remote Rack using CNB Cards			27
Appendix A.5.1. Hardware and Software requirements			27
Appendix A.5.2.		Setup	27
Appendix A.5.3.		RSLogix configuration	27
Appendix A.5.4.		RSNetWorx configuration	28
Appendix A.5.5.		Testing	29
Appendix A.5.6. Connection limitations -Controlling the SlotServer using ControlNet			30
Appendix A.6. Rules for Naming Logix driver Data Arrays			31
APPENDIX B.	TROUBLESHOOTING TIPS		33
Appendix B.1.	Things to check when communications fail		33

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com Tel: (408) 262-2299 Fax: (408) 262-2296 Toll_Free: 888-509-1970 email: support@fieldServer.com

Image 3

Contents Applicability & Effectivity Table of Contents Appendix B Troubleshooting Tips Introduction About this product Rslogix Required configuration for the SlotServerLoad the SlotServer Configuration into the SlotServer Install the SlotServer in a ControlLogix RackWrite the SlotServer configuration Install the FieldServer UtilitiesSlotServer Ports and Displays SlotServer InstallationLED Inside Cover Door Label Technical SpecificationsSlotServer Topology Data Arrays/Descriptors Configuring the SlotServer as a Logix I/O ServerServer Side Node Descriptors Server Side Connection DescriptorsDriver Specific Map Descriptor Parameters Map Descriptors Example Establish an RSLogix project5 Add and configure the SlotServer as an IO Module Write Ladder Program to get Input Data from Data Arrays FS-RA-CLXSlotServerInstructionManualT17011 Very Important Note Set up the third party connection Write Ladder Program to Send Output Data to Data ArraysDownload the RSLogix Program and Run Multiple Input Data Arrays Accessing Multiple Output Data ArraysVery Important Note FS-RA-CLXSlotServerInstructionManualT17011 SlotServer Data Transfer over IO Data Image Appendix A.2. The IO image header Appendix A.3. How to obtain Node Status from the SlotServerAppendix A.4. Dealing with ControlLogix RPI Settings Appendix A.5.3. RSLogix configuration Appendix A.5.2. SetupAppendix A.5.4. RSNetWorx configuration Appendix A.5.5. Testing FS-RA-CLXSlotServerInstructionManualT17011 Appendix A.6. Rules for Naming Logix driver Data Arrays Rdbc CPU1 INT Wrbc CPU1 INTFS-RA-CLXSlotServerInstructionManualT17011 This page Intentionally Left Blank

APPENDIX B.

TROUBLESHOOTING TIPS