Infinite Peripherals 216, KPM-210 user manual For the 300 dpi model

3. PRINTER FUNCTIONS

for the 300 dpi model :

			Vertical direction			Horizontal direction
	m	Mode	N. dots	DPI		DPI	(Tab.A.3)
							N. of Data (k)
	0	8 dot single	8	100		150	nL + nH x 256
		density
	1	8 dot double	8	100		300	nL + nH x 256
		density
	32	24 dot single	24	300		150	(nL + nH x 256) x 3
		density
	33	24 dot double	24	300		300	(nL + nH x 256) x 3
		density
[Notes]		• The nL and nH commands indicate the number of dots of
		the bit image in the horizontal direction. The number of dots
		is calculated using: nL + nH ⋅			256.

•If the bit image data input exceeds the number of dots to be printed on a line, the excess data is ignored.

•d indicates the bit image data. Set a corresponding bit to 1 to print a dot, or to 0 to not print the dot.

•If the value of m is outside the specified range, nL and data following it are processed as normal data.

•If the width of the printing area set by GS L and GS W is less than the width required by the data set using ESC * , the excess data are ignored.

•To print the bit image use LF, CR, ESC J or ESC d.

•After printing a bit image, the printer returns to normal data processing mode.

•This command is not affected by the emphasized, double- strike, underline (etc.) print modes, except for the upside- down mode.

•The relationship between the image data and the dots to be printed is as follows:

KPM210/216

3- 18 www.ipcprint.com