I/O Magic MagicSpin manual Mounting Your CD-ROM Drive, Locate an available drive bay

Page 11

Mounting Your CD-ROM Drive

Locate an available drive bay.

Locate an empty drive bay within your computer. It may be necessary to remove a square iron plate. Please refer to your computer’s User’s Guide for assistance.

Slide the MagicSpin CD-ROM drive into the empty bay.

Attach the MagicSpin CD-ROM with the four included screws. Use a Phillips head screwdriver to secure both sides of the CD-ROM. Make sure that you tighten the screws fully.

Figure 4: Insert CD-ROM into 5.25 drive bay

Connect the power supply cable.

Connect the power supply cable into the Power Connector on the back of the MagicSpin CD-ROM drive (Figure 5)

Figure 5: CD-ROM connections

Image 11
Contents Magicspin Page Page Table of Contents Before You Begin Installation InstructionsIntroduction System RequirementsCD-ROM Technology Technical backgroundATA Packet Interface Atapi IDE/ATA InterfaceEnhanced IDE Interface Setting Master or Slave Jumpers CD-ROM Hardware InstallationPrepare Your Computer for Installation Connecting a Secondary IDE controller Connecting to a Primary IDE ControllerSlide the MagicSpin CD-ROM drive into the empty bay Connect the power supply cableMounting Your CD-ROM Drive Locate an available drive bayRe-attach the computer’s cover Connect the IDE interface cableConnect the Audio cable from your Sound Card If necessary Enabling Ultra DMA/33 support under Windows 98/95 CD-ROM Software InstallationWindows 98/95 Installation Windows NT 3.5x InstallationPower on your PC and go to the Dos prompt Windows NT 4.0 InstallationDOS or Windows 3.1x Installation Click ADD and select IDE CD-ROM and click installMSCDEX.EXE CD Audio Installing CD AudioCare and Handling Using the CD-ROM DriveUse Registry Editor at your own risk TroubleshootingCD-ROM Troubleshooting Page Disc Appendix a CD-ROM General SpecificationsRegister Your I/OMagic Product Contacting I/OMagicDT-CD32A-001-981101