I/O Magic MagicSpin manual Connect the IDE interface cable, Re-attach the computer’s cover

MagicSpin Installation Guide

Connect the IDE interface cable.

Connect the 40 pin IDE cable into the MagicSpin CD-ROM drive’s IDE connector located on the back of the CD-ROM drive (Figure 5).

Figure 6: IDE connection

Make sure to align the red-lined edge of cable with Pin-1 of the IDE connector. Connect the other end into either your motherboard IDE controller, or your IDE controller card plugged into your motherboard (Figure 6).

Figure 7: Connection to Motherboard

Connect the Audio cable from your Sound Card (If necessary).

If you have a sound card or an audio interface card, use the audio cable to connect from the sound card audio port (SONY or IDE) to the MagicSpin CD-ROM drive’s Analog Audio connector located on the back panel (Figure 4).

Re-attach the computer’s cover.

Page 12