MagicSpin Installation Guide
Click ADD and select IDE CD-ROM and click install
Windows NT 4.0 Installation
Power on your PC.
Start the Windows NT
Once in the desktop, click on the Start button > Settings >
Control Panel > Devices
Select "ATAPI" from the list and click on the "Startup" button
When you get the startup screen, check "Boot" then click The "OK" button
Close the Devices screen and click on the Start button > Shut
Down and restart the computer
Note: If the setup program asks for floppies instead of prompting for the current driver, exit setup, and copy the ATAPI.SYS file from your NT setup Disk to directory \WINNT35\SYSTEM32\DRIVERS, then run the above setup procedure again.
DOS or Windows 3.1x Installation
Power on your PC and go to the Dos prompt.
If your PC boots into Windows 3.X automatically, you need to exit Windows to the Dos prompt.
Insert the driver diskette into a floppy drive.
Type A:\install (where A:\ is your floppy drive)
Follow the instructions on the screen.
Follow the instructions on the screen to complete the rest of the installation process.
Remove the Driver Diskette and Reboot your computer.
Once the installation is complete, remove the driver diskette and reboot your computer. This is necessary for your computer to detect your new
Page 14