I/O Magic MagicSpin manual Appendix a CD-ROM General Specifications, Disc

Page 20

MagicSpin Installation Guide

Appendix A: CD-ROM General Specifications

Disc

ISO9660 Data Discs CD-ROM (Mode 1 & Mode 2),

Disc Format:

 

CD-R and CD-RW media,

 

Mixed Mode (Audio Combined CD-ROM Discs),

 

CD-ROM/XA (Mode 2 form 1 & form 2), CD-

 

I/FMV, Video CD, CD-DA, Photo-CD (Single &

Disc Diameter:

multisession), Karaoke CD, CD-extra.

 

8cm and 12cm

Interface:

ATAPI / IDE

Audio Specifications

65 dB typical

Signal to Noise Ratio:

Headphone Level:

>0.6 Vrms at 1 Khz, 32 ohm load

Compatibility

 

Operating System:

DOS 6.xx, Windows 3.1X, Windows 95, Windows

 

NT, OS/2 Warp 3.x/4.x

Quality and Reliability:

MTBF up to 60,000 hours

Environment

10 to 45 degrees Celsius

Operating Temperature:

Storage Temperature:

-15 to 60 degrees Celsius

Operating Humidity:

20% to 80% (Non-condensing)

Storage Humidity:

20% to 90% (Non-condensing)

Front Panel:

Power ON/Busy LED, Open/Close Button,

 

Volume Control, Stereo Headphone Jack,

 

Emergency Eject Hole

Rear Panel:

IDE Interface, Analog & Digital Audio Outputs,

 

Power Input, Mode Select Jumper

Physical Dimensions

 

W x H x D:

146 x 41.5 x 201 mm

Weight:

<94-g typical

Power Requirement:

DC +5V +5%, DC +12V +10%

Power Saving:

Compliant with EPA Energy Star

Page 20

Image 20
Contents Magicspin Page Page Table of Contents Installation Instructions IntroductionSystem Requirements Before You BeginTechnical background CD-ROM TechnologyIDE/ATA Interface ATA Packet Interface AtapiEnhanced IDE Interface Setting Master or Slave Jumpers CD-ROM Hardware InstallationPrepare Your Computer for Installation Connecting to a Primary IDE Controller Connecting a Secondary IDE controllerConnect the power supply cable Mounting Your CD-ROM DriveLocate an available drive bay Slide the MagicSpin CD-ROM drive into the empty bayRe-attach the computer’s cover Connect the IDE interface cableConnect the Audio cable from your Sound Card If necessary CD-ROM Software Installation Windows 98/95 InstallationWindows NT 3.5x Installation Enabling Ultra DMA/33 support under Windows 98/95Windows NT 4.0 Installation DOS or Windows 3.1x InstallationClick ADD and select IDE CD-ROM and click install Power on your PC and go to the Dos promptMSCDEX.EXE Installing CD Audio CD AudioUsing the CD-ROM Drive Care and HandlingUse Registry Editor at your own risk TroubleshootingCD-ROM Troubleshooting Page Appendix a CD-ROM General Specifications DiscContacting I/OMagic Register Your I/OMagic ProductDT-CD32A-001-981101