Section 2 - Installing RAM into the Elite 12 Series Printer
1.Switch off the printer.
2.Unplug the interface cables from the back of the printer. Do not unplug the power cord from the AC outlet.
3.If necessary, move the printer so that you have clear access to its left side.
4.Remove the paper tray.
5.Open the top cover by pressing the release button on the top right of the printer.
6.Remove the side cover. Unscrew the two thumbscrews at the rear of the printer (A). If these are tight, you may need to use a #2
Phillips screwdriver.
C
B
A
A
7. Reach inside the case. Pull the edge of the cover (B) toward you, then move the cover away from the rest of the printer to prevent it from latching again.
B
3