Section 3 - Installing RAM into the Elite XL 20 Series Printer
1.Switch off the printer.
2.Unplug the interface cables from the back of the printer. Do not unplug the power cord from the AC outlet.
3.If necessary, move the printer so that you have clear access to its left side.
4. Remove the side cover. Unscrew the two thumbscrews at the rear of the printer, as shown. If these are tight, you may need to use a #2 Phillips screwdriver.
5. Slide the left cover assembly towards the rear of the printer. Swing out the bottom edge first and then lower the left cover out of the guide channel.
LOCALTALKRS | |
| - 422 |
| SCSI |
PARALLEL | |
10 | |
| |
AAUI |
|
8